Rugged Ridge 11504.37 User manual

Copyright © 2019 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Rugged Ridge Rocker Guards, JL 2-Door
Page 1/3
Part #11504.37
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649
FOR WARRANTY OR TECH CONCERNS EMAIL: [email protected]
Components
1. Hex Head Cap Screw, M8 x 1.25............................................ 4
2. Lock Washer, M8....................................................................... 4
3. Flat Washer, M8, 28mm OD ..................................................... 4
4. Hex Head Cap Screw, M6 x 1.0.............................................. 8
5. Flat Washer, M6, 22mm OD ................................................... 16
6. Nylon Lock Nut, M6 .................................................................. 8

Copyright © 2019 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Rugged Ridge Rocker Guards, JL 2-Door
Page 2/3
Part #11504.37
2. With assistance, attach the Rocker Guard to the
back of the pinch weld using the included
(4) 6mm x 25mm Hex Bolts,
(8) 6mm Flat Washers and
(4) 6mm Nylon Lock Nuts.
Leave hardware loose at this time.
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS
ARE PRESENT. READ INSTRUCTIONS CAREFULLY.
FACTORY INSTALLED OR AFTERMARKET “ROCK RAILS,”
SIDE STEPS OR RUNNING BOARDS MUST BE REMOVED.
ASSISTANCE IS HIGHLY RECOMMENDED.
Start installation on the driver side of the vehicle.
Locate the (2) pairs of holes in the pinch weld.
Directly behind each pair of holes, locate the 8mm
threaded hole in the oor of the vehicle.
NOTE: Threaded holes may be covered with
undercoating. Scrape off excess undercoating to
provide a at surface for brackets.
3. Attach the mounting tabs on the Rocker Guard to
the (2) threaded holes in the oor with the included
(2) 8mm x 35mm Hex Bolts,
(2) 8mm Lock Washers and
(2) 8mm Flat Washers.
Adjust the Rocker Guard and tighten all hardware
M6 Pinch
Weld Hareware
M8 Rocker Guard Hareware
M8 Rocker
Guard Hareware M6 Pinch
Weld Hareware

Copyright © 2019 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Rugged Ridge Rocker Guards, JL 2-Door
Page 3/3
Part #11504.37
4. Repeat Steps 2 - 5 for passenger/right side Rocker
Guard installation.
Do periodic inspections to the installation to make
sure that all hardware is secure and tight.
To protect your investment, wax this product after
installing. Regular waxing is recommended to add a
protective layer over the nish. Do not use any type
of polish or wax that may contain abrasives that
could damage the nish. Mild soap may be used to
clean the Rocker Guard.