Rugged Ridge Elite Tail 11226.13 User manual

Copyright © 2020 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Elite Tail Light Guard, Wrangler JL
Page 1/4
Patent Pending
Part #11226.13
1. Guard, LH (1)
2. Rear Housing, LH (1)
3. Rear Housing, RH (1)
4. Guard, RH (1)
5. Bolts (8)
6. Screws (6)
7. Foam Strip (1)
Components
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649
FOR WARRANTY OR TECH CONCERNS EMAIL: [email protected]
1
2
4
3
5 6 7

Copyright © 2020 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Elite Tail Light Guard, Wrangler JL
Page 2/4
Patent Pending
3. Remove OE mounting bracket by unscrewing Phil-
lips head screws.
2. Using either a 10mm or T40 torx socket, unscrew OE
mounting bolt and carefully pull tail light away from
vehicle. Unplug tail light by sliding red tab rst. Then
press down on gray tab and gently pull plug from
light.
1. Lift plastic cover in cargo area to gain access to
tail light mounting bolt.
1
2

Copyright © 2020 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Elite Tail Light Guard, Wrangler JL
Page 3/4
Patent Pending
6. Cut and attach Foam Strips to area shown.
5. Using supplied Bolts, attach Guard to Rear Housing.
Guard and Housing are either marked R or
L to distinguish right and left side.
4. Position supplied Rear Housing between OE mount-
ing bracket and tail light. Using supplied Screws, at-
tach Rear Housing and OE mounting bracket to tail
light.
Be careful not to pinch wires between
Housing and tail light.
NOTICE
NOTICE

Copyright © 2020 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Elite Tail Light Guard, Wrangler JL
Page 4/4
Patent Pending
7. Reconnect Tail light to factory wire harness. Reus-
ing OE tail light mounting bolt, attach tail light and
new Tail Light Guard to vehicle.