Rugged Ridge 11250.23 User manual

Rugged Ridge 60 in. RGB Lighted Whip w/ Controller (07-17 Wrangler JK) Installation Guide
Installation Time: 1-2 Hours
Tools Required:
Socket Wrench
13mm Socket
7/8” Wrench or Socket
A few wire connectors
Installation Instructions:
1. Remove spare tire
2. Install CB Antenna mount by removing the two 13mm hex bolts on the top right of the spare tire mount, and
installing the CB antenna mount using the hex bolts, lock washers, and flat washers that are given. (Seen in the
photo in step 3)
3. Unscrew the lighted whip from the whip mounting cylinder. Place this in one of the holes of the CB antenna
mount

4. Put the washer, lock washer, and 7/8” nut onto the whip mounting screw.
5. Tighten with a 7/8” Wrench

6. Attach the whip to the whip mounting cylinder.
7. Screw the supplied wire to the whip.

8. Run the whip wire through the rear tailgate.
9. Run the wire through the area that the third brake light wiring is held.

10. At this point, you will need to find a place to splice the whip wire into. I chose to splice it into some lights that I
have that are underneath the seats, but it will vary from person to person.
11. Finished
Installation Instructions Written by ExtremeTerrain Customer Thomas Sandoval 10/10/2017