Rugged Ridge 11544.22 User manual

Copyright © 2018 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.omix-ada.com
JL Spartacus Stamped Front Bumper Overrider
Page 1/2
Part #11544.22
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | TICKET: www.omixsupport.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
6
4
2
3
1
5
1. Overrider (1)
2. Support Bracket, LH (1)
3. Overrider Bracket, RH (1)
4. Gasket (2)
5. M10 Nut (2)
6. M10 Washer (2)
Components

Copyright © 2018 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.omix-ada.com
JL Spartacus Stamped Front Bumper Overrider
Page 2/2
2. Align Gasket with mounting holes in top of
Stamped Bumper. Using supplied M10 hardware,
attached Overrider to Spartacus Front Bumper.
Tighten all loose hardware.
Compete steps 2-8 on Spartacus
Stamped Front Bumper instruction.
1. Remove OE Outer Frame Bracket Bolt. Using
removed OE bolt, loosely attach Support Bracket to
vehicle’s frame.