Rugged Ridge 11509.32 User manual

Copyright © 2018 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Rear Tube Doors; JK Wrangler
Page 1/2
Part # 11509.32
1. Tube Door - Left (1)
2. Tube Door - Right (1)
3. Hinge Pin - Left (2)
4. Hinge Pin - Right (2)
5. M8 Bolt (8)
6. M8 Washer (16)
7. M8 Lock Nut (8)
8. Check Strap (2)
Components
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649
FOR WARRANTY OR TECH CONCERNS EMAIL: [email protected]

Copyright © 2018 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
Rear Tube Doors; JK Wrangler
Page 2/2
1:5 Scale
View DS vehicle
Right arrow key 2x
Down arrow key 1x
1:5 Scale
View DS vehicle
Right arrow key 2x
Down arrow key 1x
3. Using caution, slowly insert Tube Door in door hinges
and reinstall factory door nuts.
2. Loosely install Hinge Pins on Tube Doors using
supplied M8 hardware.
1. Remove doors from vehicle as instructed in factory
supplied user manual.
Door removal may require assistance
from another person.
Tube Door installation may require
assistance from another person.
NOTICE
NOTICE
4. Close Tube Door and tighten Hinge Pin hardware.
Install Check Strap and cycle Tube Door open and
closed to ensure Hinge Pins are properly aligned and
fully seated in door hinge.
If door does not close after Hinge
Pin alignment, loosen two M6 bolts
securing latch box to door. Adjust
latch box position until door closes
properly.
NOTICE