Rugged Ridge 12300.53 User manual

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
4-Door JK Magnetic Body Panels
Page 1/3
Part #12300.53
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
1
2
3
4
5
6
78
9
10
11
12
13
14
4-Door Components
1. Front Fender, LH (1)
2. Front Fender, RH (1)
3. Front Door, LH (1)
4. Front Door, RH (1)
5. Rear Door, LH (1)
6. Rear Door, RH (1)
7. Door Seam #1 (2)
8. Door Seam #2, LH (1)
9. Door Seam #2, RH (1)
10. Door Seam #3, LH (1)
11. Door Seam #3, RH (1)
12. Rear Fender #1 (1)
13. Rear Fender #2 (1)
14. Rear Fender #3 (1)

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
4-Door JK Magnetic Body Panels
Page 2/3
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
To Install Magnetic Body Panels
1.Ensure area of vehicle and panels are clean by washing with a mild cleaning agent and air
drying or drying with a soft cloth.
Sub-zero temperatures may affect the strength of the Magnetic Body Panels. Installing
Magnetic Body Panels in sub-zero temperatures is not recommended
2. Afx panels to vehicle as shown below. If panels need to be adjusted, remove entire panel
and reapply.
Sliding Magnetic Body Panels on vehicle surface could cause scratching on vehicle
surface or deformation of Magnetic Body Panels. To reposition, remove entire panels
Driver’s Side

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
4-Door JK Magnetic Body Panels
Page 3/3
Passenger’s Side
Care and Maintenance
-Remove Magnetic Body Panels daily or after each use, especially if exposed to rain, mud, or other
harsh conditions. Clean panels and vehicle and allow both to dry before reapplying.
-When not using Magnetic Body Panels, store in a clean, dry place, avoiding extreme
temperatures. Storing in direct sunlight could cause damage or fading to the material.
-Store Magnetic Body Panels at on a level surface to prevent warping or damage to the material.
Do not allow magnetic surfaces to face one another.