Rugged Ridge 11504.36 User manual

Copyright © 2018 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
RRC Rocker Guards, JL Wrangler (4 Door)
Page 1/2
Part # 11504.36
1. Rocker Guard - Right (1)
2. Rocker Guard - Left (1)
3. Mounting Bracket - Right (1)
4. Mounting Bracket - Left (1)
5. Flag Bolt (2)
6. Plastic Washer (4)
7. U-Bolt (2)
8. M10 Bolt (4)
9. M10 Washer (14)
10. M10 Lock Nut (10)
Components
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649
FOR WARRANTY OR TECH CONCERNS EMAIL: [email protected]

Copyright © 2018 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | www.Omix-ADA.com
RRC Rocker Guards, JL Wrangler (4 Door)
Page 2/2
3. Remove two M10 nuts from body mount in front
of rear wheel. Loosely install Rocker Guard on studs
using factory M10 nuts.
2. Install Mounting Bracket on vehicle frame using
supplied M10 washers and lock nuts.
1. Locate cross member under front doors. Insert Flag
Bolt and U-Bolt in holes in frame as shown. Use Plastic
Washers to prevent hardware from falling into frame.
4. Attach Rocker Guard to Mounting Bracket using
supplied M10 hardware. Once attached, tighten all
mounting hardware.
Rocker Guard installation may require
assistance from another person.
Use caution while inserting hardware
into frame. If dropped it may be
difcult to remove.
NOTICE
NOTICE