Samsung Yepp YP-T6H Quick start guide

[How to upgrade the firmware of YP-T6]
(Very Important !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!)
You have to upgrade the firmware in recovery mode.
Please upgrade the firmware like below.(to upgrade in recovery mode)
(Save the important data to the other storage before upgrading the YP-T6!!)
<Upgrading the firmware >
1. Remove the battery from YP-T6.
2. While pressing the "Play"buttonof YP-T6, connect YP-T6 to the PC. You have to press the
"Play"buttoncontinuously.
3. Execute the "YP-T6 Updater"forupgrading the firmware. You have to press the
"Play"buttoncontinuously.(Normally it takes 10 seconds.)
In case of searching device driver, you have to click “ Next”to go on.(Important!!). It needs more
time.
(In case of searching device driver)

4. If "YP-T6 Updater"'sprogressive bar is gone by(There is some image on the LCD of YP-T6), you
can release the "Play"button.
5. If "YP-T6 Updater"isavailable, you have to upgrade the firmware after checking the format combo
box.
6. If "YP-T6 Updater"upgradingjob is completed, close the upgrading job.

7. After disconnect the "Removable disk"safely, disconnect the USB cable of the YP-T6.
8. After Entering the YP-T6's Menu
→
Settings
→
System
→
About, check the firmware version.
9. All is done. Thank you.
FAQ)
1) It doesn't work after upgrading the firmware.
→
It is recommended to connect YP-T6 to the PC in recovery mode and upgrade the
firmware.(Refer to the above procedure.)
2) While connecting USB in recovery mode, there is protocol error..
→
Use the rear USB port of the PC for connecting USB.
(It is recommended for upgrading the firmware safely)