Sanipex BAGNODESIGN ALPINE BDS-MEG-701-PPI User manual

BAGNODESIGN
  
General Installion Guide
ALPINE
COUNTERTOP/
WALLMOUNTED
WASH BASIN
NOTE: for illustrative purposes only an 800mm wash basin is shown, please follow the sa
me
procedure to install the other Alpine produ cts. wider basins may require an additional bracket
 
Please leave these instructions with the customer

TOOLS REQUIRED (Not supplied)

 
 � JOI �I 




Drill and drill bits
Required when securing the wash basin to a wall. Use an appropriate size bit to
match the wall fixing chosen (wall screws and fixings may not be supplied).
Remove the basin from its packaging carefully.

Mark a horizontal line at between 850-900mm for the height of the basin (A) subtract
the depth of the basin and this will give the bracket height (B). Use the supplied basin
to give you the dimension of the bracket width(C) mark the fixing hole using the
bracket. Required 3 brackets for the long wash basins above 1200mm width.
Drill the marked holes with the correct size drill bit for the plug. Insert the 6 plugs
into the holes.
INSTALLATION

Fasten the the brackets to the wall using 6 screws.
Place the basin o.nto the fixing brackets and ensure that they are aligned
correctly.

Using screws, secure the basin to the fixing brackets (screws not supplied).
Apply silicon around the perimeter of the basin touching the wall
INSTALLATION COMPLETE!!!

INS-ALPINE WALLBASIN