Sanipex BAGNODESIG BDM-MLI-406 Series User manual

BDM-MLI-406-XX
M-LINE DIFFUSION FLOOR MOUNTED BASIN MIXER
www.sanipexgroup.com

IMPORTANT PLEASE READ

 

 






 L  C 



 x 
            
           
 



     








 









Preparation before installation
Spout
Mixer body
Base plate
Concealed
Box*1
Fixing screw*4
Allen wrench*3
Fixing bolts*4
Silicon oil bag*1
Installation kit
Make a slot underground size must
over 120 x 130 mm, depth
70-100mm including the upper
brick.
HOT
COLD
120mm
130mm
Connect the concealed valve with
plumbing, open the valve and get
the leakage test done properly.
Drill installation holes in the
bottom (Ø8mm×4), then install
the fixing bolts into the holes.
HOT
COLD
50mm
97mm
4-Ø8mm
Depth 70-100mm
(including ceramic tile)

Put in the concealed box and
fasten it with M4 screws, ensure it
is in horizontal measuring by the
level.
Decorating with upper bricks.
Take off the upper cover, loosen
the fixing bolts M5*4. Then take
off the 4 pcs O-rings, bottom
flange and testing plug by steps.
Cut the plastic socket to ensure it
is in the same horizontal level as
the brick face.
Bottom
flange
Testing pleg
Fixing bolts
M5*4
Flat lid
O-ting*4
Make sure the bubble is in the
middle position of lever to ensure
the valve installed in horizontal.

Apply some silicon
oil onto the bottom
of the spout, install
the spout with the
mixer body, fasten
the spout. Put the
base plate through
the middle hole of
the mixer body, then
using fixing bolts to
install the plate with
the bottom flange.
Apply
silicon oil
Apply silicon
oil
Install the upper
mixer body kit with
the valve beneath,
and fasten it the
base plate with
fixing bolts O-ring.
Installation Finished

Note:

INM-MLI-406-XX-05-23
www.sanipexgroup.com