Sanipex BAGNODESIGN BDM-SES-309-X-XX User manual

BAGNODESIGN
  
Installation Guide
BDM-SES-309-X-XX
SESTRIERE CONCEALED 3 HOLE BASIN MIXER
 
Please leave these instructions with the customer

TECHNICAL SPECIFICATIONS
Minimum hydraulic pressure: 0,5 bar Maximum hydraulic
pressure: 10 bar Recommended working pressure: from 1 to 5
bar
Tested pressure: 16 bar
Temperature of inlet hot water: 80°C Suggested temperature
(Energy sa-ving): 60°C
Functioning automatic diverter:
≥ 0,5 bar (dynamic pressure)
It is very important that hot and cold water temperature will
be balanced as much as possible to grant the optimum
performance of the mixer.
If pressure is higher than 5 bar it is advisable to install a water
pressure reducer. The employ of these mixers with low
pressure hot water accumulators is not suitable.
1

SCHAFT INSTALLATION
Fig. 1
2
Pierce a proper hole in the wall and fit the body (1) with the protection
parts, be careful of the limits (MIN-MAX) onto the protection itself.
Suggested the use of the spirit level for a proper alignment between the
body (1) and the wall. Connect the inlet hot/cold water tubes (2) to the
body (1).

Fig. 2
Fig. 3
3
Proceed with the plastering and the final covering always giving a look
to the limits (MIN-MAX).

Fig. 4
4
Unthread the protection parts (3).

Fig. 5
5
Install the spout (4) with its base ring (5) toward the final covering and
secure with the grub screw (6).

Fig. 6
6
Finally fit the cup (7) with its washer (8) and screw the cap and the
handle (9).
Final installaton

Use soft cloth, soapy solution and water for regular care.Wipe
with a dry cloth.
Avoid the use of abrasives or solvents, which damage the
surface. Damage caused by inappropriate treatment by the
user, is not covered by our guarantee.
CLEANING
7

Note: