Sanuvox SANUVAIR S600 User manual

1-888-726-8869 www.sanuvox.com Sanuvox Technologies INC. All rights reserved. 2021-v.2
INSTALLATION MANUAL
SANUVAIR®S600
AIR PURIFICATION SYSTEM
PLEASE SAVE FOR YOUR RECORDS
DATE INSTALLED : _________________________
INSTALLER CONTACT INFO. : _______________________________________________________________
INSTALLED BY: ___________________________

1-888-726-8869 www.sanuvox.com
A
B
C
D
E
F
H
J
K
L
G
I
Sanuvox Technologies INC. All rights reserved. 2018-v.1
INSTALLATION MANUAL
WARNING
The unit must be unplugged from any
power source before servicing. An electric
shock can cause injuries. Do not expose
your eyes or skin to the UV lamps. Do not
handle the new UV lamp without a pair
of gloves. The UV lamp contains a small
amount of mercury, dispose of the used
lamp according to local regulations. Use
only Sanuvox branded replacement lamps.
The use of any other lamps will have a direct
impact on the units performance and will
void the warranty.
A. Grill
B. Outlet fan motor
C. Aluminum chamber
D. UV lamp location
E. Inletlter
F. Door contact
G. Fan speed control
H. Lamp ON/OFF toggle switches
I. Access door
J. Handles (one on each side)
K. Power Cord
L. LED indicator for lamp and ballast operation

1-888-726-8869 www.sanuvox.com Sanuvox Technologies INC. All rights reserved. 2021-v.2
INSTALLATION MANUAL
STEP 1
Pick ideal location
Locateawallthattheunitwouldbemountedonandwherenocauseforobstructionwillpreventtheunitsairowtorun
properly.Theunitshouldbemountedverticallywiththeoutletfanpositiontowardstheceilingandtheinletltertowards
theoor.Aminimumclearanceof12inchesshouldbeleftovertheunitforadequateairrelease.Aminimumclearanceof
24inchesshouldbeleftundertheunitforadequateairintake.
STEP 2
Mount system to wall
After measuring the minimum clearance from the ceiling of the room, mount and install the support bracket horizontally on
the wall with the lip facing the ceiling.
12inminimumclearance
over the system
24inminimumclearance
under the system
Secure the bottom clamp on the wall where
a padlock can be installed to fasten the unit
at the bottom.
Using the units handles located on each
side of the system, position the unit on the
support bracket and center the unit from left
to right.

1-888-726-8869 www.sanuvox.com Sanuvox Technologies INC. All rights reserved. 2021-v.2
INSTALLATION MANUAL
STEP 3
Lamp installation
Open the access door and install the UV lamps on the connector using the supplied pair of gloves. When pushing the
lampintotheconnector,makesureyourhandisholdingtheceramicendcapandnottheclearquartzpartofthelampand
opentheclampatthesametime.Oncethelampisrmlyintoposition,releasetheclampthatwillholdthelampinplace.
Proceed the same with the two other lamps.
STEP 4
Operation
Inconsiderationoftheroomsairvolume,turnON,1,2or3lamps.The“Maintenance”sectionbelowwillgiveyoua
guidanceonhowmanylampscouldbeturnedONwiththeairvolume.Movethefanmotorrheostattothedesiredfan
speed.Thesuggestion,ifnoiseisn’tanissue,istohavethefanspeedtoitsmaximumposition.Finally,closethedoor,
powertheunitbypluggingitintoawalloutletof120V.
Maintenance
Once a year change the UV lamps that are turned ON.
Note1:Ifonelampoutof3wereturnedON,youcansimplyturnthatlampOFFandturnasecondunusedlampON.If2
lamps were turned ON, you can turn OFF the lamps that were ON, and turn ON the lamp that was OFF, and change the
other two lamps and turn ON a second lamp, and so on.
Note2:Ifonly1or2lampsareturnedON,onlytheLEDforthoselampswillalsobelitontheoutsidepanel.
Parts for SANUVAIR®S600
BST1201277GLR Replacementballast
LMPRGU65 Replacementlamp