SARAH ELLISON EARTH DINING TABLE User manual

sarahellison.com.au page 4 | 4 sarahellison.com.aupage 1 | 4
EARTH DINING TABLE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Earth Dining Table. This
document lists the contents included in your delivery. Please take the time to
identify the hardware, as well as the individual components of this product.
As you unpack and prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.
HARDWARE
16 x 1/4x20mm bolt screws
TOOLS REQUIRED
Allen key
PEOPLE REQUIRED FOR
ASSEMBLY
A minimum of two people are
required to assemble this product
ESTIMATED TIME OF ASSEMBLY
30 minutes
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of purchase.

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Unpack the table top and base from each carton of packaging. Open
box carefully, ensuring the blade of the knife does not come into
contact with the product.
Place the table top face down onto a clean, flat, surface (we
recommend using a towel or sheet underneath for protection).
Arrange the the legs on the underside of the table and fasten each of
the bolts provided into the table using the provided allen key.
sarahellison.com.aupage 3 | 4
STEP 3
CARE INSTRUCTIONS
Carefully turn the table over (2 persons are recommended). When
lifting and flipping your table to be the correct way up, do not use the
legs as a tilting point. Their connection to the table top is not designed
to be a leverage point and the level of load through this joint may
cause the legs to be damaged or break. It is our recommendation that
you check and tighten all screws every 6 months.
With a little care you can prolong the life of your furniture. The following
information is only intended as a general guideline. Please follow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
Our timber pieces are all treated and sealed for everyday living, but
it is important to be mindful in their placement, as extreme conditions
(such as harsh sunlight) can change the colour of the timber. Timber
is responsive to its environment, be mindful that heat and moisture
can cause movement and cracks in joints and damage lacquer. We
recommend using placemats and trivets to avoid spills soaking into the
timber, and to also protect against heat transfer. The general rule is if
something is too hot to hold, it is too hot to place on timber. Should spills
occur, wipe immediately with a damp cloth. Periodically also check and
re-tighten any fasteners, we recommend every six months.