SARAH ELLISON LIZA User manual

sarahellison.com.aupage 1 | 4
LIZA CONSOLE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Liza Console. This document
lists the contents included in your delivery. Please take the time to identify the
hardware, as well as the individual components of this product. As you unpack
and prepare for assembly, place the contents on a carpeted or padded area to
protect them from damage.
HARDWARE
8x Allen Bolt (H-1)
8x Spring Washer (H-2)
TOOLS REQUIRED
4mm Allen Key L (T-1)
PEOPLE REQUIRED FOR
ASSEMBLY
A minimum of two people are
required to assemble this product
ESTIMATED TIME OF ASSEMBLY
30 Minutes
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of purchase

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Open box carefully, ensuring the blade of the knife does not come into
contact with the product. Remove packaging and lift the product up out
of box and gently place on ground.
Lay the Table Top upside down onto a padded, non-marring surface.
Lift the first leg into place, aligning the holes on the metal tongues to
the corresponding holes on the Table Top base as shown. Secure the
Leg using Allen Bolts (H-1) and Spring Washers (H-2), stacking the
hardware in the order shown. Engage all bolts by hand first, then fully
tighten them using Allen Key (T-1). Repeat the process above to install
the second Leg.

sarahellison.com.aupage 3 | 4
STEP 3
Once the legs are secure, with a second person assisting you, rotate
the console upright and position the console in your room. Don’t forget
to recycle the packaging where possible. Levelers on the leg bases may
be used for additional leveling and adjustment if needed.
CARE INSTRUCTIONS
With a little care you can prolong the life of your furniture. The following
information is only intended as a general guideline. Please follow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
Rattan is responsive to its environment, be mindful that heat and moisture can
cause movement and cracks in joints and damage lacquer.
• Avoid exposing rattan to direct heat and sunlight
• Wipe up spills immediately with a clean, dry cloth.
• Use coasters for drinks to prevent moisture from contacting surfaces.
• Keep rough and sharp objects away from rattan surfaces. Where
possible, apply protective pads to the undersides of items being displayed
on rattan surfaces, including those with rubber feet or bumpers.
• Dust rattan frequently with a soft, slightly damp lint-free cloth, and then
wipe dry.
• Avoid using abrasives, harsh chemicals and aerosol-powered cleaners
• For persistent spots, gently clean with a soft cloth and a solution of water
and mild detergent. Wipe dry.
• Avoid furniture polish as it can accumulate over time and leave a residue

sarahellison.com.au page 4 | 4