SARAH ELLISON EARTH User manual

page 1 | 4 sarahellison.com.au
EARTH OUTDOOR ROUND COFFEE TABLE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Earth Outdoor Round Coffee Table.
This document lists the contents included in your delivery. Please take the time
to identify the hardware, as well as the individual components of this product.
As you unpack and prepare for assembly, place the contents on a carpeted or
padded area to protect them from damage.
HARDWARE
16x Allen Bolt (H-1)
16x Spring Washer (H-2)
16x Flat Washer (H-3)
TOOLS REQUIRED
4mm Allen Key L (T-1)
PEOPLE REQUIRED FOR
ASSEMBLY
A minimum of two people are required
to assemble this product
ESTIMATED TIME OF ASSEMBLY
15 mins
CUSTOMER SERVICE
For Australian customer service contact: [email protected]
For any international customer service inquires please contact the retailer of purchase

page 2 | 4sarahellison.com.au
STEP 1
STEP 2
Pull out all four legs out of the boxes. Please note that Metal Mounting
Plates are pre-assembled to the concrete legs. Carefully check that
connections are tight. If needed, re-tighten Metal Mounting Plate with leg
using Allen Key (T-1).
Open box carefully, ensuring the blade of the knife does not come into
contact with the product. Remove packaging and lift the product up out
of box and gently place on ground.

page 3 | 4 sarahellison.com.au
X16
STEP 3
Once the legs are secure, with a second person assisting you, rotate
the table upright and position the table in your room. Don’t forget
to recycle the packaging where possible.
Lay the Table Top upside down onto a padded, non-marking surface.
Lift the first leg into place, aligning the holes on the metal mounting
plates to the corresponding holes on the Table Top base as shown.
Secure the Leg using Allen Bolts (H-1) ,Spring Washers (H-2) and Flat
Washer (H-3), stacking the hardware in the order shown. Engage all
bolts by hand first, then fully tighten them using Allen Key (T-1). Repeat
the process above to install the other three Legs.
STEP 4
T-1
H-1
H-3
H-2

page 4 | 4sarahellison.com.au
CARE INSTRUCTIONS
With a little care you can prolong the life of your furniture. The following information is
only intended as a general guideline. Please follow the instructions to ensure maximum
longevity of your Sarah Ellison furniture.
• Dust often using a clean, soft, dry and lint-free cloth.
• When blot spills, wipe with a clean, damp cloth immediately.
• We do not recommend the use of chemical cleansers, abrasives or furniture polish on
our waxed finish.
• Hardware may loosen over time. Periodically check to make sure all connections are
tight. Re-tighten if necessary.