SARAH ELLISON PIERRE MIRROR User manual

sarahellison.com.aupage 1 | 4
PIERRE MIRROR
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Pierre Mirror. This document
lists the contents included in your delivery. Please take the time to identify
the hardware, as well as the individual components of this product. As you
unpack and prepare for assembly, place the contents on a carpeted or
padded area to protect them from damage.
NOTE: Be sure to use hardware appropriate for your wall type. Whenever
possible, attach mounting hardware into a wall stud. If you are unsure about
what hardware method you should use, consult a qualified professional or
your local hardware store.
HARDWARE
1 x Wall hook screw anchor
1 x Plastic screw anchor
2 x Safety wall straps
2 x Washers
2 x M4x12mm screws
TOOLS REQUIRED
Power drill (not supplied if required)
Screwdriver (not supplied)
Measuring Tape (not supplied)
PEOPLE REQUIRED FOR
ASSEMBLY
A minimum of two people are
required to assemble this product
ESTIMATED TIME OF ASSEMBLY
30 minutes
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of purchase

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Open the box carefully, ensuring the blade of the knife does not come
into contact with the product. Remove packaging and lift the product
out of the box and gently place face down onto a clean, flat, surface
on the ground. We recommend using a towel or sheet underneath for
protection.
Holding the mirror in place, determine where you wish to hang/
lean your mirror and mark on the wall where the wall screw anchor
should be inserted. Drill a hole into the wall to house the plastic screw
anchor. A pilot hole is recommended to be drilled for installation.
Insert the plastic screw anchor (A) and tighten until flush with the wall
surface. Screw the provided wall hook screw anchor (B) clockwise into
the plastic screw anchor until tight and secure. The hook should be
pointing towards the ceiling.
WALL
A
Pilot
Hole
B

sarahellison.com.aupage 3 | 4
STEP 3
STEP 4
Lift the mirror into place with the assistance of another person and
check that the wall hook is in the correct location, with the D-ring
secured over the wall hook.
If you decide to use this mirror as a floor mirror, we strongly
recommend that you install the provided anti-tip kit to prevent the
mirror from accidentally falling and causing injury or damage. With the
mirror in place (but unhooked), stand the mirror parrallel to the wall
6-8 inches out and secure the anti-tip kit to the wall using two washers
per fixing and the appropriate fixings for your wall type. Once secure,
lean and hook the mirror in place using the attached D-rings.
WALL
WALL
WALL
WALL

sarahellison.com.au page 4 | 4
CARE INSTRUCTIONS
With a little care you can prolong the life of your furniture. The following
information is only intended as a general guideline. Please follow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
• Keep rough and sharp objects away from rattan surfaces.
• Dust frequently with a soft, slightly damp lint-free cloth, and then wipe
dry.
• Avoid exposing rattan to direct heat and sunlight
• Avoid using abrasives, harsh chemicals and aerosol-powered cleaners
• Although resistant to rust, powdercoated metals will oxidize if the
coating is chipped, scratched or exposed to harsh chemicals and UV
rays over time.