SARAH ELLISON STACEY II User manual

sarahellison.com.aupage 1 | 4
STACEY II DINING TABLE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Stacey II Dining Table. This
document lists the contents included in your delivery. Please take the time to
identify the hardware, as well as the individual components of this product.
As you unpack and prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.
HARDWARE
1 x Marble Top
1 x Top Assembly Frame
1 x Base Drum
1 x Base Assembly Plate
4 x 16x8mm Flat Head Bolt
8 x 16x8mm Countersunk Bolt
4 x 25x8mm Flat Washer
TOOLS REQUIRED
Allen key (provided)
PEOPLE REQUIRED FOR
ASSEMBLY
A minimum of two people are
required to assemble this product
ESTIMATED TIME OF ASSEMBLY
30 minutes
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of purchase

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Open the box carefully, ensuring the blade of the knife does not
come into contact with the product. Lift the Base Drum onto a clean,
flat surface. We recommend using a towel or sheet underneath for
protection.
Place the Base Assembly Plate on top of the drum, aligning the bolt
holes. Use the Countersunk Bolts and Allen Key to attach the two
components together.
With someone to assist you, lift and turn the base assembly so that the
Base Plate is now on the floor. Place the Top Assembly Frame on top of
the drum, aligning the bolt holes. Use the Countersunk Bolts and Allen
Key to attach the two components together.

sarahellison.com.aupage 3 | 4
STEP 3
STEP 4
With someone to assist you, unpack and lift the Marble Top into place
above the drum, aligning the bolt holes underneath.
Use the Flat Head Bolts and Allen Key to attach the two components
together from the underneath. Position in your room, and don’t forget
to recycle the packaging where possible. Periodically check and re-
tighten any fasteners, we recommend every six months.

sarahellison.com.au page 4 | 4
CARE INSTRUCTIONS
With a little care you can prolong the life of your furniture. The following
information is only intended as a general guideline. Please follow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
Stone and marble are naturally occurring organic materials, and can contain
variations in grain, colour or texture. These dierences are to be expected as
individual characteristics of the material and inject personality into the item.
Our stone is treated with a protective coating however all spills should
be cleaned quickly to avoid stains. Wipe spills immediately with a damp,
clean cloth to avoid staining, as stone is naturally porous, the longer the
spill remains, the harder it is to remove. We recommend that you use mats
and coasters to protect your marble and stone from heat, scratches and
permanent marks. Stone is a natural product of the earth and must be
cleaned with gentle cleaners. Do not use scouring cream or scouring pads,
as they may scratch the surface. Never use acidic or abrasive cleaners or
vinegar on either stone or marble surfaces.
Although resistant to rust, powdercoated metals will oxidize if the coating is
chipped, scratched or exposed to harsh chemicals and UV rays over time. Do
not use harsh solventbased, abrasive or stainless steel cleaners. These will
accelerate staining, fading and ultimate failure of the powdercoated finish.
We recommend using a mild soap product.
Periodically also check and re-tighten any fasteners, we recommend every six
months.