SARAH ELLISON MUSE OUTDOOR ARMLESS MODULE User manual

sarahellison.com.au page 4 | 4
CARE INSTRUCTIONS
sarahellison.com.aupage 1 | 4
MUSE OUTDOOR ARMLESS MODULE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Muse Outdoor Armless Module. This
document lists the contents included in your delivery. Please take the time to
identify the hardware, as well as the individual components of this product.
As you unpack and prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.
HARDWARE
Alligator Clip (Pre-Installed)
TOOLS REQUIRED
None
PEOPLE REQUIRED FOR
ASSEMBLY
Two people are recommended to place
this product
ESTIMATED TIME OF ASSEMBLY
15 mins
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of
purchase
With alittle care you can prolong thelife of your furniture. The following
information isonly intended as a general guideline. Pleasefollow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
• Dirt and stains are unavoidable oncushions used outdoors, so
• therefore do not leavethem outside in the rain.Cover them or
•bring them indoors when not used.
•Remove loosedirt or debris to avoid thefabric from staining. Remove
• dirt or spills immediately. Clean the fabric with a soft cloth and mild
• detergent. Always cleanthe entire surface of thefabrictoavoid water
• rings.Always test a small, less visiblearea of thefabricfirst before
•cleaning any visible surface.
•We do not recommend the use of chemical cleansers, abrasives or
• furniture polish on our lacquered finish.

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Open box carefully, ensuring the blade of the knife does not come into
contact with the product.
Remove packaging and lift the product up out of box and gently place
on ground.
sarahellison.com.aupage 3 | 4
STEP 3 - Optional
STEP 4
To connect the module pieces together to make a larger sofa, turned
the preassembled aligator clip outwards and align the ‘male’ and
‘female’ connector pieces on the sides of the module and slide
together.
Position in your room, and don’t forget to recycle the packaging where
possible