SARAH ELLISON GABRIELLA User manual

sarahellison.com.aupage 1 | 4
GABRIELLA FLOOR MIRROR
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Gabriella Floor Mirror. This
document lists the contents included in your delivery. Please take the time to
identify the hardware, as well as the individual components of this product.
As you unpack and prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.
NOTE: Be sure to use hardware appropriate for your wall type. Whenever
possible, attach mounting hardware into a wall stud. If you are unsure about
what hardware method you should use, consult a qualified professional or
your local hardware store.
HARDWARE
2x Mounting Hooks (H-1)
4x Nails (H-2)
TOOLS REQUIRED
Measuring tape (Not supplied)
Hammer (Not supplied)
PEOPLE REQUIRED FOR
ASSEMBLY
A minimum of two people are
required to assemble this product
ESTIMATED TIME OF ASSEMBLY
30 minutes
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of purchase

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Open box carefully, ensuring the blade of the knife does not come into
contact with the product. Remove packaging and lift the product up out
of box and gently place on ground.
Holding the mirror in place, determine where you wish to hang your
mirror and mark on the wall where the mounting hook anchor should
be inserted - in line with the D-ring hooks on the rear of the mirror.
Attach the mounting hook brackets to the wall.

sarahellison.com.aupage 3 | 4
STEP 3
Lifting the mirror carefully, hook the D-rings on the rear of the mirror
over the wall hook brackets. The nut on the wall mounting brackets can
be rotated to adjust the length of wall mounting brackets if adjusting
and leveling is needed.
CARE INSTRUCTIONS
With a little care you can prolong the life of your furniture. The following
information is only intended as a general guideline. Please follow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
Rattan is responsive to its environment, be mindful that heat and moisture can
cause movement and cracks in joints and damage lacquer.
• Avoid exposing rattan to direct heat and sunlight
• Keep rough and sharp objects away from rattan surfaces.
• Dust rattan frequently with a soft, slightly damp lint-free cloth, and then
wipe dry.
• Avoid using abrasives, harsh chemicals and aerosol-powered cleaners
• For persistent spots, gently clean with a soft cloth and a solution of water
and mild detergent. Wipe dry.
• Avoid furniture polish as it can accumulate over time and leave a
residue

sarahellison.com.au page 4 | 4