SARAH ELLISON PEPE User manual

sarahellison.com.aupage 1 | 4
PEPE SIDE TABLE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the Sarah Ellison Pepe Side Table. This document
lists the contents included in your delivery. Please take the time to identify
the hardware, as well as the individual components of this product. As you
unpack and prepare for assembly, place the contents on a carpeted or
padded area to protect them from damage.
NOTE: Be sure to use hardware appropriate for your wall type. Whenever
possible, attach mounting hardware into a wall stud. If you are unsure about
what hardware method you should use, consult a qualified professional or
your local hardware store.
HARDWARE
2 x Anti-tip Cables
4 x Washers
2 x M4x12mm screws
TOOLS REQUIRED
Power drill (not supplied if required)
Screwdriver (not supplied)
Measuring Tape (not supplied)
PEOPLE REQUIRED FOR
ASSEMBLY
1 Person
ESTIMATED TIME OF ASSEMBLY
30 Minutes
CUSTOMER SERVICE
For Australian customer service contact : [email protected]
For any international customer service inquires please contact the retailer of purchase

sarahellison.com.au page 2 | 4
STEP 1
STEP 2
Open box carefully, ensuring the blade of the knife does not come into
contact with the product. Remove packaging and lift the product up out
of box and gently place on ground. Position in your room, and don’t
forget to recycle the packaging where possible
We strongly recommend that you install the provided anti-tip kit
to prevent the table from accidentally falling and causing injury or
damage. Gently lay the console face down onto a clean, flat, surface
on the ground. We recommend using a towel or sheet underneath for
protection. With a screw driver, secure the anti-tip kit to the table by
screwing the M4x12mm screws and washers into the pre-drilled pilot
holes on the underneath face at the rear of the table.

sarahellison.com.aupage 3 | 4
STEP 3
STEP 4
Place the table in place, sitting 6-8 inches out from the wall and mark
on the wall where the anti-tip cables should be attached. Drill a hole
into the wall to suit the appropriate fixings for your wall type. A pilot
hole is recommended to be drilled for installation. Fasten the anti-tip
cables to the wall using washers and appropriate fixings for your wall
type.
Move your table back in place against the wall.
WALL

page 4 | 4
CARE INSTRUCTIONS
With a little care you can prolong the life of your furniture. The following
information is only intended as a general guideline. Please follow the
instructions to ensure maximum longevity of your Sarah Ellison furniture.
Timber is responsive to its environment, be mindful that heat and moisture
can cause movement and cracks in joints and damage lacquer.
• Avoid exposing wood to direct heat and sunlight
• Maintain consistent humidity in the space to prevent excessive
expansion and contraction of wooden pieces and joints.
• Wipe up spills immediately with a clean, dry cloth.
• Over time, air and sunlight will change the colour of natural wood.
Occasionally rotate the items placed on your wood furniture to allow
a more uniform colour to develop. Expose table leaves to the same
amount of air and sunlight as your table
• Use coasters for drinks to prevent moisture from contacting surfaces.
• Use trivets for hot pans and dishes to prevent damage to finishes and
underlying wood.
• Keep rough and sharp objects away from wood surfaces.
• Apply protective pads to the undersides of items being displayed on
wood surfaces, including those with rubber feet or bumpers.