SATO MB200 User manual

PN 9001119A
MB200
Direct Thermal Printer
PARTS LIST

SATO America, Inc.
10350A Nations Ford Road
Charlotte, NC 28273
Main Phone: [phone]
Technical Support Hotline: [phone]
Technical Support Fax: [phone]
E-Mail: satosale[email protected]
www.satoamerica.com
ATTENTION
SOME COMPONENTS IDENTIFIED WITHIN THIS DOCUMENT HAVE DUAL PART NAMES. THE FIRST
(ON THE LEFT) IS THE PART NAME AS ASSIGED BY CORPORATE AND IS THE ONE THAT SHOULD
BE USED WHEN PLACING AN ORDER FOR REPLACEMENT PARTS.
THE SECOND (IN PARENTHESIS) IS THE PART NAME THAT IS USED IN THE OPERATOR AND
SERVICE MANUALS. THESE INCORPORATE TERMINOLOGY MORE COMMONLY APPLIED IN THE
UNITED STATES.
THE ABOVE MENTIONED NAMES MAY BE FOUND IN THE “PART DESCRIPTION” COLUMN OF THE
TABLES WITHIN THIS DOCUMENT.
THIS DOCUMENT IS PROVIDED FOR GENERAL IN FORMATION AND IS SUBJECT TO CHANGE
WITHOUT NOTICE. SATO AMERICA, INC. MAY NOT BE HELD REPSONSIBLE FOR ERRORS THAT
MAY APPEAR.
WARNING
THE EQUIPMENT REFERENCED IN THIS DOCUMENT COMPLIES WITH THE REQUIREMENTS IN
PART 15 OF FCC RULES FOR A CLASS B COMPUTING DEVICE. OPERATION OF THIS EQUIPMENT
IN A RESIDENTIAL AREA MAY CAUSE UNACCEPTABLE INTERFERENCE TO RADIO AND TV
RECEPTION REQUIRING THE OPERATOR TO TAKE STEPS TO CORRECT THE INTERFERENCE.

SATO MB200 Parts List PN 9001119A Page 1
FRONT HOUSING COVER ASSEMBLY
*The purchase of item 3 is required if replacing item 2.
**The purchase of item 9 is required if replacing Item 8.
Figure PL1, Front Cover Assembly
ITEM PART NUMBER PART DESCRIPTION QTY
2 PR0A30105 FRONT HOUSING COVER 1
3 PH2A30100 K/B PANEL (CONTROL BOARD PANEL)* 1
4 PE1A30200 IrDA BRACKET 1
5 PE1A30300 IrDA ADJUSTMENT KNOB 1
6 PE1A31600 POWER SWITCH PLATE 1
8 PH0A30800 DIP SW WINDOW (DIP SWITCH COVER)** 1
9 Q00295001 DIP SWITCH COVER HINGE STICKER 1
10 PE0A30100 INTERFACE CONNECTOR CAP 1
11 PE0A30200 AC SUPPLY CONNECTOR CAP 1
12 R01992000 MAIN PCB ASSY (MAIN CIRCUIT BOARD) 1
13 RJ4A30301 IrDA ASSEMBLY 1
15 MH1200522 P-TIGHT SCREW, FLAT HEAD 2
5
4
13
3
8
2
6
9
12
11
15
A
A
B
B
C
C

SATO MB200 Parts List PN 9001119A Page 2
RIGHT HOUSING COVER ASSEMBLY
Figure PL2, Right Housing Cover Assembly
ITEM PART NUMBER PART DESCRIPTION QTY
4 PR0A30302 DISPENSER UNIT SET (DISPENSER COVER) 1
5 PE1A31700 DISP SW BUSH (DISPENSER LATCH) 2
6 PC1A30300 DISPENSER LATCH SPRING 2
7 PE1A31801 LOWER DISPENSER COVER 1
8 PE1A32500 DISP PLATE (DISPENSER SENSOR BRACKET) 1
9 MH1200522 P-TIGHT SCREW, FLAT HEAD 3
10 R00075001 P ROLLER (FEED ROLLER) 1
11 PB0A30802 P SHAFT (FEED ROLLER SHAFT) 1
12 ND0020030 SNAP RING, TYPE E 2
13 PC1A30210 DISP PR SPRING (FEED ROLLER SPRING) 2
14 PH0A30401 TOP CABINET (TOP HOUSING COVER) 1
15 MH0200522 P-TIGHT SCREW, PAN HEAD 2
16 RH1A30302 DISPENSER SENSOR 1
17 PT9A30200 SPACER 2
9
7
5
13
4
16
11
6
12
10
17
12
6
5
15
9
8
14
BA SE CO VER A SSY 2 4
BA SE COVER A SSY
FRONT COVER ASS
Y

SATO MB200 Parts List PN 9001119A Page 3
CHASSIS & PRINT ASSEMBLY
ITEM PART NUMBER PART DESCRIPTION QTY
1 PH0A30600 BOTTOM CABINET (PRINTER CHASSIS) 1
2 PE0A20000 FOOT (CHASSIS BOOT) 2
3 PH0A30203 RADIO MASK 1
4 MH0200522 P-TIGHT SCREWS, PAN HEAD 2
5 PV2A30120 FOOT RUBBER (TOP HOUSING COVER STOP, RUBBER) 1
6 PE1A32300 CENTER GUIDE (MEDIA RAMP) 1
7 MH0200522 P-TIGHT SCREW, PAN HEAD 2
8 PH0A30701 BATTERY COVER 1
9 PA1A30700 BATTERY SHEET 1
10 PT9A30500 SPACER (SLEEVE) 2
11 PT9A30400 SPACER (COLLAR) 2
14 PE1A30700 PRINT HEAD BRACKET 1
15 PA1A30200 GAP SENSOR PROTECTER 1
16 PE1A32400 PRINT HEAD OPEN/CLOSE CAM 1
17 PB0A30510 PRINT HEAD OPEN/CLOSE CAM SHAFT 1
18 PC2A30100 PRINT HEAD OPEN/CLOSE CAM SPRING 1
19 PE1A30900 PRINT HEAD OPEN/CLOSE CAM 1
20 PE1A31000 P BUSH (PRINT HEAD BALANCE SHAFT COLLAR, RIGHT) 1
21 PB0A30401 HEAD P SHAFT (PRINT HEAD BALANCE SHAFT) 1
22 PE1A31100 P BUSH (PRINT HEAD BALANCE SHAFT COLLAR, LEFT) 1
23 PE1A30403 PRINT HEAD OPEN/CLOSE LEVER 1
24 MH0200522 P-TIGHT SCREW, PAN HEAD 2
25 PE6A30200 PRINT HEAD CUSHION 2
26 NA1020022 FLAT WASHER 1
27 MH0200522 P-TIGHT SCREW, PAN HEAD 1
32 GH900041A THERMAL HEAD (PRINT HEAD ASSEMBLY) 1
33 MD3200622 SCREW W/ FLAT WASHER & SPRING WASHER, PAN HEAD 2
34 PE1A30800 PRINT HEAD BRACKET 1
35 PE1A32600 HEAD AJUST BUSH (PRINT HEAD BUSHING) 2
38 PC1A32110 PRINT BALANCE SPRING 2
39 PR2A30000 BELT CLIP 1
40 PE1A32101 CLIP BUSH (CLIP SHAFT CAPS) 2
41 P00804000 CLIP SPRING 1
42 PB0A30901 CLIP SHAFT 1
43 RH1A30401 PRINT HEAD OPEN SWITCH 1
44 RH1A30202 GAP SENSOR ASSEMBLY 1

SATO MB200 Parts List PN 9001119A Page 4
Figure PL3, Print & Chassis Assemblies
45 RH1A30100 BATTERY CABLE ASSEMBLY 1
46 PE1A32810 FPC COVER (BATTERY CONNECTOR COVER) 1
ITEM PART NUMBER PART DESCRIPTION QTY
14
22 43
25
38
21 20
23
19
18
44
17
16
15
34
32
33
27
26
35
35
39
40
1
41 3
4
40
2
5
24
42
6
7
24
45
8
9
11
11
10
46

SATO MB200 Parts List PN 9001119A Page 5
TOP HOUSING COVER ASSEMBLY
ITEM PART NUMBER PART DESCRIPTION QTY
1 PH0A30306 OPEN COVER (TOP HOUSING COVER) 1
2 PH0A31001 OPEN COVER PLATE (TOP HOUSING COVER PLATE) 1
3 PJ0A30200 DRIVE GEAR, 34/16*0.5 1
4 PJ0A30300 DRIVE GEAR, 44/16*0.5 1
5 PR1A30001 DRIVE MOTOR BRACKET 1
6 RJ4A30101 DRIVE MOTOR, STEPPER 1
7 MH0200522 P-TIGHT SCREW, PAN HEAD 4
10 PE1A30602 SENSOR HOLDER (PLATEN ROLLER BRACKET) 1
11 PR0A30203 PLATEN ROLLER ASSEMBLY 1
13 PE1A32900 LABEL GUIDE (MEDIA GUIDE, RIGHT) 1
14 MH0200522 P-TIGHT SCREW, PAN HEAD 2
15 PE1A30500 DRIVE MOTOR COVER 1
16 MH0200522 P-TIGHT SCREW, PAN HEAD 1
18 PR8A30100 SHAFT (DISPENSER BAR) 1
19 PE1A31300 LABEL HOLDER (MEDIA HOLDER) 1
20 MH0200522 P-TIGHT SCREW, PAN HEAD 3
21 PR0A30400 LABEL GUIDE (MEDIA GUIDE, LEFT) 1
22 PE1A31400 GUIDE STOPPER 2
23 MH0200522 P-TIGHT SCREW, PAN HEAD 2
24 PE2A30100 MEDIA COLLAR 1
25 PE1A32700 LOCK HOLDER (LATCH) 1
26 MH1200522 P-TIGHT SCREW, FLAT HEAD 2
28 PB0A31300 HINGE SHAFT (HINGE PIN) 1
29 RJ4A30200 SENSOR ASSEMBLY 1

SATO MB200 Parts List PN 9001119A Page 6
Figure PL4, Top Cover Assembly