sauter TVL-XL User manual

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-mail: [email protected]
Tel. : +49-[0]7433- 9933-0
Fax: +49-[0]7433-9933-149
Internet: www.sauter.eu
Installation manual
SAUTER TVL-XL / TVL-XLS
V. 1.0
10/2022
EN
TVL-XL-BA-en-2210.docx

2 TVL-XL-BA-en-2210.docx
EN
SAUTER TVL-XL / TVL-XLS
V. 1.0 10/2022
Installation manual
1 Introduction
These assembly instructions describe the assembly of the TVL-XLS set or the
extension of your TVL test stand with the TVL-XL accessory.
2 Dismantling TVL
2.1 Dismantle length measuring device
Remove the cap screw that fixes the angle of the linear encoder to the base plate.
2.2 Dismantle base plate
Remove the four screws from the bottom of the base plate.
2.3 Brass bush
Remove the brass bush from the base plate.

TVL-XL-BA-en-2210.docx 3
3 Installation TVL-XL
3.1 Extension set on base plate
Mount the extension set on the base plate using the screws (4), hexagon nuts (5) and
washers (6) supplied. The mounting plate for linear encoders must be on the top of the
right side of the test stand.
3.2 Brass bush
Insert the brass bushing into the top of the extension kit. Now screw the upper part of
the TVL test stand to the extension set with the screws (4) and washers (6).
3.3 Length measuring device
Finally, fix the length measuring device to the plate of the extension set with the screw
(8), washers (9) and hexagon nut (10).

4 TVL-XL-BA-en-2210.docx
4 TVL and TVL-XL assembled together