Scott LUMEN 2023 User manual

2023 LUMEN eRIDE | ENGLISH 1
|
2023 SCOT T
LUMEN eRIDE MANUAL

2023 LUMEN eRIDE | ENGLISH 2
|
LUMEN eRIDE
GEOMETRY & TECHNICAL DATA 03
HEADSET ADJUSTMENT 05
SETTING SAG 06
TWINLOC 07
TQ SYSTEM MANUALS 07
CABLE ROUTING 08
SPARE PARTS 11
MANUFACTURE’S GUARANTEE 15
LEGEND
T2
10Nm
TORQUE REQUIRED TORX TOOL SIZE
HEX TOOL SIZE
TORQUE AMOUNT
TASK DIFFICULTY
NO GREASE REQUIRED
GREASE REQUIRED
CARBON GREASE REQUIRED
THREADLOC REQUIRED
CONTENT
THE LUMEN eRIDE SHOULD BE ADJUSTED EXACTLY TO THE RIDER FOR MAXIMUM SAFETY AND
RIDEABILITY.
Please contact your authorized SCOTT dealer for advice in order to avoid technical problems or any harm.
BEARING FIT REQUIRED

2023 LUMEN eRIDE | ENGLISH 3
|
LUMEN eRIDE
GEOMETRY & TECHNICAL DATA
MY23 LUMEN eRIDE SM MED LG XL
AHead tube angle ° 65.5 65.5 65.5 65.5
BHead tube length mm 110 110 120 135
CTop tube horizontal mm 562 589 620 645
Dstandover height mm 765 767 780 800
EBB offset mm -38.5 -38.5 -38.5 -38.5
FBB height mm 338.5 338.5 338.5 338.5
G Wheelbase mm 1176 1206 1240 1270
IBB center to TST mm 415 440 480 520
JSeat angle ° 76.8 77 77.2 77.5
K Chainstay mm 450 450 450 450
L Reach mm 416 446 476 501
M Stack mm 615 615 625 638
Fork Length mm 540 540 540 540
Trail mm 126 126 126 126
SEATPOST mm 31.6
SEATPOST CLAMP mm 34.9
TRAVEL mm 130 Rr 150 Ft
SHOCK LENGTH mm 165
SHOCK STROKE mm 45
HARDWARE M.FRAME mm Trunnion
HARDWARE LINKAGE mm 8 x 20
MAX ROTOR mm 200 Rr 200 Ft
MAX CHAINRING Tooth 36
MAX TYRE WIDTH in 2.6
CHAINLINE mm 55

2023 LUMEN eRIDE | ENGLISH 4
|
LUMEN eRIDE
LUMEN eRIDE
GEOMETRY & TECHNICAL DATA CONT.
Please observe the maximum seatpost insertion
so not to damage the frame.
Small: 150 mm Max Insertion
Medium: 175 mm Max Insertion
Large: 215 mm Max Insertion
X-Large: 255 mm Max Insertion
Please note that on the small sized frame it
is only possible to use a 500 ml water bottle,
with a side entry cage.

2023 LUMEN eRIDE | ENGLISH 5
|
LUMEN eRIDE
It is important to install the headset correctly
depending on the set up required. There are
two types of headset cups.
0° & 0.6° ( 64° & 65°) These can be indentified
from the stamp on the inner surface of the
headset cup.
The headset is available in two options:
288251 SYN HEADSET ZS56/28.6-ZS56/40 MTB
290060 SCO HEADSET CUP KIT SPARK 22
Do not use a standard headset tool
to remove these plastic headset
cups.
LUMEN eRIDE
HEADSET ADJUSTMENT
Slacker
Steeper

2023 LUMEN eRIDE | ENGLISH 6
|
LUMEN eRIDE
LUMEN eRIDE
SAG ADJUSTMENT
01 02
Wear your normal riding gear, set the
sage meter to zero & the twinloc in
the open position.
If the sag value is not to your liking
within the sag range indicated, adjust
the shock pressure as indicated above.
You may need to use this specific valve
extender depending on which shock
pump you have.
297520
Gently sit on the bike allowing the
sag meter to move. Once completed
dismount the bike gently. Check the
value.
SCO eRIDE REAR SHOCK VALVE
EXTENDOR 23

2023 LUMEN eRIDE | ENGLISH 7
|
LUMEN eRIDE
Motor Manual Battery Manual
Range Extender ManualDisplay Manual
Charger Manual
LUMEN eRIDE
TWINLOC
LUMEN eRIDE
TQ SYSTEM MANUALS
LUMEN NAME PART NO. CAM TYPE DROPPER
LUMEN eRIDE 900 SL TWINLOC TSP3 290009 BLUE CAM YES
LUMEN eRIDE 900 TWINLOC TSP3 290009 BLUE CAM YES
LUMEN eRIDE 910 TWINLOC TSP3 290009 BLUE CAM YES

2023 LUMEN eRIDE | ENGLISH 8
|
LUMEN eRIDE
LUMEN eRIDE
CABLE ROUTING
Rear Brake & Rear Derailleur
Dropper Seatpost

2023 LUMEN eRIDE | ENGLISH 9
|
LUMEN eRIDE
LUMEN eRIDE
CABLE ROUTING
Twinloc
Speed Sensor

2023 LUMEN eRIDE | ENGLISH 10
|
LUMEN eRIDE
LUMEN eRIDE
CABLE ROUTING
TQ System

2023 LUMEN eRIDE | ENGLISH 11
|
LUMEN eRIDE
LUMEN eRIDE
SPARE PARTS
290054 SCO HANDLEBAR CABLEGUIDE KIT MTB IC 22
297270 SCO eRIDE CABLEGUIDE/COVER KIT LUMEN 23
297269 SCO eRIDE SHOCK COVER LUMEN 23
297516 SCO eRIDE INTERNAL CABLEGUIDE 23
297265 SCO eRIDE BRAKE MOUNT LUMEN 23

2023 LUMEN eRIDE | ENGLISH 12
|
LUMEN eRIDE
LUMEN eRIDE
SPARE PARTS CONT.
420010 SCO LUMEN eRIDE 23 CS/ST PROTECTOR
297266 SCO eRIDE CHAINGUIDE LUMEN 23
290016 SCO AXLE RWS 148X12 SPARK PLUG 22
290059 SCO STEM SPACER/TOP CAP SY MTB XC 22
290057 SCO STEM SPACER/TOP CAP SY MTB COMBO 22
290058 SCO STEM SPACER/TOP CAP SY MTB DC 22
25Nm
286000 SCO DROPOUT SRAM UDH 21
297671 SCO DROPOUT SHIMANO UDH DM 23
Reverse Thread

2023 LUMEN eRIDE | ENGLISH 13
|
LUMEN eRIDE
LUMEN eRIDE
SPARE PARTS CONT.
290056 SCO HEADSET SPACER KIT IC MTB 22
297673 SCO MAIN PIVOT SPARK 22/LUMEN 23
294540 SCO eRIDE TQ RANGER EXTENDER HOLDER
294537 SCO eRIDE TQ RANGE EXTENDER
292668 BLD SHOCK NOODLE LINKIN 22

2023 LUMEN eRIDE | ENGLISH 14
|
LUMEN eRIDE
LUMEN eRIDE
SPARE PARTS CONT.
294538 SCO eRIDE TQ RANGE EXTENDER CABLE MTB
294767 SCO eRIDE LINKAGE BAR INNER LUMEN 23
296217 SCO eRIDE TQ LOCKRING SET 23
296209 SCO eRIDE TQ SPEEDSENSOR 23
296216 SCO eRIDE TQ H-BAR REMOTE SET 23

2023 LUMEN eRIDE | ENGLISH 15
|
MANUFACTURER’S GUARANTEE,
When purchasing a new SCOTT bicycle from an authorized SCOTT dealer, SCOTT grants a
manufacturer’s guarantee subject to the following provisions.
CONDITIONS
The manufacturer’s guarantee is only granted to the first-time buyer of a SCOTT bicycle who has
purchased it from an authorized SCOTT dealer. The manufacturer’s guarantee only applies if the
bicycle is registered to the first buyer at www.scott-sports.com within ten days of purchase.
DURATION
The manufacturer’s guarantee is granted from the date of purchase for a period of five years on
bicycle frames and rear ends. The guarantee period is reduced to three years, if the SCOTT bicycle
is not serviced at least once a year by an authorized SCOTT dealer. Maintenance services must be
carried out in accordance with the maintenance instructions in the SCOTT manual and must be
confirmed there by the stamp and signature of the authorized SCOTT dealer.
For frames and rear ends of Category 5 bicycle models and for rigid forks manufactured by
SCOTT, the duration of the manufacturer’s guarantee is limited to two years.
If a defect on the SCOTT bicycle is remedied within the scope of a manufacturer’s guarantee or a
warranty claim, the duration of the manufacturer’s guarantee is not extended. The manufacturer’s
guarantee ends, when the first-time buyer transfers ownership of the SCOTT bicycle to a third
person.
ASSERTION
The manufacturer’s guarantee is provided by SCOTT Sports SA, Route du Crochet 11, 1762 Givisiez,
Switzerland. The buyer must inspect the SCOTT bicycle immediately after purchase and notify
his authorized SCOTT dealer at once in writing of any obvious defects. Hidden defects must be
reported immediately after their discovery. In the event of a guarantee claim, the SCOTT bicycle
must be handed over to an authorized SCOTT dealer. The latter will contact SCOTT to remedy the
defect. The assertion of a guarantee claim always requires the presentation of the original proof
of purchase as well as the proof of maintenance service in the SCOTT manual.
Performance of SCOTT in the event of a guarantee claim
In the event of a guarantee claim, SCOTT will, at its own discretion, repair the defect or replace
the defective product with a product of similar quality, whereby colour and model deviations are
possible. If a repair or replacement is not possible, a purchase price refund will be made taking
into account previous use. SCOTT is entitled to commission third parties to remedy the defect.
LIMITATIONS
The manufacturer’s guarantee applies exclusively to frames, swingarms and rigid forks of SCOTT
bicycles. Bicycle components are excluded from this manufacturer’s guarantee.
The manufacturer’s guarantee does not apply to normal wear and tear, damage caused by
accidents or other excessive force on the SCOTT bicycle, corrosion, improper maintenance,
incorrect assembly and assembly of unsuitable components or accessories as well as cosmetic
defects, for example in the varnish.
The manufacturer’s guarantee does not apply to SCOTT bicycles that have been used in a rental
shop.
MISCELLANEOUS
These manufacturer’s guarantee provisions apply to all SCOTT bicycles as of model year 2023.
Statutory warranty rights of the buyer and guarantees of component manufacturers (Shimano,
SRAM etc.) remain unaffected by this
manufacturer’s guarantee.
The place of jurisdiction for all disputes in
connection with this manufacturer’s guarantee
is Freiburg, Switzerland. This manufacturer’s
guarantee is subject to Swiss law to the
exclusion of all legislation that refers to foreign
law.

2023 LUMEN eRIDE | ENGLISH 16
|
© SCOTT Sports SA 2023. All rights reserved.
The information contained in this manual is in various languages
but only the English version will be relevant in case of conflict.
P.E.D Zone C1, Rue Du Kiell 60 | 6790 Aubange | BelgiumDistribution: SSG (Europe) Distribution Center SA
SCOTT Sports SA | 11 Route du Crochet | 1762 Givisiez | 2022 SCOTT Sports SA www.scott-sports.com Email:
[e-mail]