PNEUMATIC CREEPER STOOL WITH
ADJUSTABLE HEIGHT SWIVEL SEAT & BACK
REST
MODEL NO: SCR03B
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
WARNING! Use the seat on level and solid ground, preferably concrete.
9Locate seat in a suitable working area.
9Keep the seat clean and tidy in accordance with good workshop practice.
8DO NOT use the seat for any purpose other than that for which it is designed.
8DO NOT stand on the seat.
8DO NOT use the seat outdoors.
8DO NOT get the seat wet or use in damp or wet locations or areas where there is condensation.
8DO NOT clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat.
8DO NOT exceed maximum capacity of 150kg.
2. INTRODUCTION
Fourleggedheavy-dutysteelconstructionwithablackpowdercoatnishforcorrosionresistance.Strengtheningringandmesh
insertforstability,alsoactsasafootrest.Ø410mmSwivelseatfeaturespneumaticheightadjustment(570to710mm),rotatesfully
through 360° and is padded with back rest for extra comfort.
3. SPECIFICATION
Model No.:............................................................... SCR03B
Capacity....................................................................... 150kg
Height(s) ............................................................. 570-710mm
4. ASSEMBLY
4.1. Unpack all parts before disposing of packaging material according to local
recycling regulations.
4.2. Invertframeandtthecastorstothelegbases.Notethelocationofthetwo
lockingcastors(g.1).
4.3. Insert gas strut into base frame.
4.4. Place seat on gas strut.
5. OPERATION
5.1. Oncethestoolisassembled,compresstheheightadjustmentleverwhilsttheseatisunloaded.Thiswillallowtheseattoreachits
maximum height.
5.2. Toadjusttheheight,pulltheswitchleverslowlywhilstsittingontheseat.Releasetheleverwhenatthedesiredheight.
6. MAINTENANCE
6.1. If in constant use, check the tightness of all fixings on a weekly basis.
6.2. Thecastorwheelsaremaintenancefree;ensuretheyarealwaysabletorotateandswivelfreely.
6.3. Clean the seat cushion and trays with a moist cloth and mild detergent.
SCR03BIssue109/12/19
Original Language Version
©JackSealeyLimited
Referto
instructions
g.1
