Sealey MS0621 User manual

Ø12-38MM WHEEL BEARING PULLER 3 JAW
MODEL NO: MS0621
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
WARNING! Familiarise yourself with the specic applications and limitations of the kit, as well as any potential hazards.
9This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer’s manual.
9Ensure that the kit is correct for the task.
9Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey stockist.
8DO NOT use the kit for any purpose other than that for which it is designed.
9Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey stockist.
9Keep children and unauthorised persons away from the working area.
8DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
8DO NOT use the kit when you are tired, or under the inuence of alcohol, drugs or intoxicating medication.
9After use, store in a safe, dry childproof area.
2. INTRODUCTION
3-Jaw design applies even pressure preventing damage to bearings. Designed to remove bearings with Ø12-38mm internal diameter. Forged
and heat treated steel jaws for greater strength. Corrosion resistant black oxide nish.
3. CONTENTS
g.1
MS0621 Issue 1 02/11/2020
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves

4. OPERATION FIG.1
NOTE: Make sure threads are clean before using bearing puller for the rst time.
4.1. Unscrew the jaws enough on the threaded bar, that the cone is not pressing on the jaws.
4.2. Insert the jaws into the middle of the bearing.
4.3. Hold the jaws and screw the threaded bar down so that the cone presses on the jaws.
4.4. Hold the nut on top of the crossbar with a spanner and wind the puller unit up.
5. MAINTENANCE
5.1. Keep all items clean and lightly oiled. Keep all threads free from grit and lubricate the thread regularly.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
MS0621 Issue 1 02/11/2020
Original Language Version
© Jack Sealey Limited