Sealey PW2012R User manual

RECHARGEABLE PRESSURE WASHER
25LTR 12V
MODEL NO: PW2012R
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. ELECTRICAL SAFETY (with respect to mains chargers)
WARNING! It is the user’s responsibility to check the following:
9You must check the AC adaptor to ensure that it is safe before using. You must inspect the power supply lead, plugs and all electrical
connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We recommend that an RCD
(Residual Current Device) is used with all electrical products. It is particularly important to use an RCD with portable products that plug
into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You can obtain a Residual Current Device
through your Sealey stockist. You must read and understand instructions concerning electrical safety.
9The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
person, using a Portable Appliance Tester (PAT), at least once a year.
9The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
9Ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply.
9Ensure that cables are always protected against short circuit and overload.
9Regularly inspect power supply, leads, plugs for wear and damage and power connections to ensure that none is loose.
1.2. GENERAL SAFETY
WARNING! DO NOT use the washer if any part of the unit, gun, nozzle, detergent bottle, hose or cables is damaged. Replace or
repair using genuine parts only. Unauthorised parts may be dangerous and will invalidate your warranty. Always check connections
are correctly secured and not cracked or damaged in any way before using the machine.
9Always be aware of the potential hazards that may occur during use. Study the applications and limitations of the washer before use.
9Keep the washer in good condition. Use an authorised agent to service the unit.
9Wear adequate protective clothing, goggles and anti-slip rubber soled footwear.
9Use where air can freely circulate around the washer to avoid the machine over-heating.
WARNING! Ensure all persons and animals keep at a minimum distance of 15m from the washer when in use.
WARNING! The pressure washer must only be used with clean water. Non-filtered water or corrosive chemicals must not be used as
they will damage the cleaner.
9Release residual pressure before disconnecting hose.
9Ensure the nozzle is aimed correctly at the working surface before activating the jet.
WARNING! DO NOT use the washer on any material containing asbestos as this may release hazardous asbestos particles
into the atmosphere.
9Keep all connections dry and off the ground.
8DO NOT direct jet against yourself, other persons or animals, electrical equipment or the machine itself.
8DO NOT use washer if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8DO NOT use the washer with flammable or toxic liquids or any other product. Only use recommended detergent. Non-recommended
detergents may corrode the machine cover and accessories.
8DO NOT connect other appliances to the machine inlet or outlet.
8DO NOT move the unit by pulling the hoses or electrical cables. Use handle.
9When not in use store in a frost proof, dry childproof location.
NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
2. INTRODUCTION
Rechargeable, lightweight, portable pressure washer which can hold up to 25ltrs of water. Ideal for many washing applications, especially where a
mains power or water supply is not available, such as car shows, track days, window cleaning or even garden use. Inside is a removable storage
tray to accommodate all the accessories. Supplied with 8m hose, variable nozzle lance, detergent bottle and a long xed brush. Detergent can
also be added to the main tank which will allow a very good distribution of foam, making washing the car extremely simple and effective. Fitted
with 4 wheels, which makes the unit easy to transport. Fitted with a strong carry handle. Supplied with mains charger and 12V in car charger.
PW2012R | Issue 1 18/12/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection

3. SPECIFICATION
Model No: ..........................PW2012R
Battery: .........................Li-ion 12V-4Ah
Capacity:................................25ltr
Charging Time: ...........................3hr
Hose Length: .............................8m
Maximum Pressure: ................ 9bar/131psi
Motor Power: ............................36W
Operating Time: ..........................2.5hr
Supply: .................................12V
Nett Weight: ............................ 4.5kg
4. OPERATION
4.1. FILLING
4.1.1. Either ll tank (g.1) with water and detergent or just water and use
detergent bottle (g.8), supplied.
9Only use recommended detergent.
(Sealey Detergent Model No’s SCS001 - SCS006)
Non-recommended detergents may damage the machine.
4.2. POWER SUPPLY
4.2.1. The washer pump is powered directly from the vehicle’s 12V accessory socket, or can be
charged with the mains charger. When fully charged will run for up to 2.5 hours.
4.2.2. To charge, plug mains charger lead in the front panel (g.2) and connect to a mains power
supply for 3 hours to fully charge.
4.2.3. Connect the 12V plug into the front panel (g.2) then insert the accessory connector
plug (g.3) into the 12V accessory socket in the vehicle.
9It is advisable to leave the vehicle engine running whilst using the washer on 12V power.
4.2.4. Use the switch on the front panel (g.2) to turn pump on and off, disconnect the plug from the
accessory socket when not in use.
4.3. PRESSURE WASHING
WARNING! Ensure pump is switched off before connecting the power lead and hose.
4.3.1. Attach the 8m hose using the push connector onto the outlet on the front panel (g.2).
4.3.2. To disconnect the hose, pull back the hose connector and release (g.4).
4.3.3. To connect the spray gun, ensure the valve on the hose is closed (g.6), then push
the hose connector onto the gun (g.5).
4.3.4. When connected, open the valve on the hose (g.7) and turn the pump on, pull the trigger,
to activate ow. Release the trigger to stop the ow of water.
4.3.5. The spray pattern may be adjusted by rotating the collar (g 5).
4.3.6. Always close the valve on the hose (g.6) and switch off the pump before removing tools.
4.4. DETERGENT DISPENSER
4.4.1. To attach the detergent bottle, ensure pump is switched off, the hose valve is closed (g.6) and
the detergent bottle switch is set to off (g.9). Connect the hose onto the detergent bottle (g.8).
4.4.2. The detergent bottle (g.8) can be removed by unscrewing from the nozzle body.
4.4.3. When lled with appropriate detergent, (Sealey Detergent Model No’s SCS001 - SCS006)
screw the bottle in place.
4.4.4. The detergent ow is started when the pump is switched on, the hose valve is open (g.7)
and the control lever on the bottle is set to either spray or jet (g.9).
4.4.5. When the detergent has been exhausted, turn off pump, close the hose valve, remove the
bottle, and rell with neat detergent.
4.5. BRUSH ATTACHMENT
4.5.1. Screw the brush handle onto the brush (g.10). Ensure the hose valve is closed and the
pump is switched off.
4.5.2. Attach the brush by pushing the hose connector onto the brush handle (g.10).
4.5.3. Switch on the pump, open the hose valve (g.7) and pull the trigger on the brush,
to activate ow into the brush head. Release trigger to stop ow, switch off pump.
5. MAINTENANCE
5.1. The pump unit does not require any regular maintenance.
5.2. The 12V connector plug is tted with an 8A fast blow cartridge fuse. If blown, replace
with identical fuse.
5.3. Should the nozzle become blocked, close the valve on the hose and disconnect the gun,
the nozzle can be back-ushed with either water or air to dislodge any blockage.
5.4. When not in use drain the machine, remove hoses and store in a cool yet frostproof
location beyond the reach of children.
PW2012R | Issue 1 18/12/18
Original Language Version
© Jack Sealey Limited
g.3
g.1
g.2
g.4
g.5
g.6 g.7

PW2012R | Issue 1 18/12/18
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. Please log on to www.sealey.co.uk, email [e-mail] or telephone [phone]
g.9
g.10
g.8