Sealey APMS58 User manual

INSTRUCTIONS FOR
MODULAR 5 DRAWER MOBILE CABINET 650MM
MODEL NO: APMS58
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this product.
8DO NOT open more than one drawer at a time.
8DO NOT step on the drawers.
9Ensure all drawers are fully closed before moving the cabinet.
9Secure the brakes when cabinet is in the desired position.
9Keep the work area clean, uncluttered and ensure there is adequate lighting.
8DO NOT use in damp work areas.
8DO NOT use the cabinet for any purpose other than that for which it was designed.
8DO NOT use the cabinet outdoors.
8DO NOT clean the cabinet with any solvents which may damage the surfaces or the protective coating.
WARNING! The warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator
2. iINTRODUCTION
Modular storage system ideal for any garage/workshop. Durable construction that will last for years. Easily adjusts to specic needs. Purchase a
simple base cabinet or create a full workshop storage system.
3. SPECIFICATION
Model no: ................................................................APMS58
Size (W x D x H):.....................................650 x 458 x 732mm
Small drawer (x2):.....................................565 x 400 x 58mm
Medium drawer (x3): ...............................565 x 400 x 135mm
4. ASSEMBLY
4.1. Fit castors
4.1.1. Carefully lay the cabinet onto its back,
(use the outer packaging to prevent damage).
4.1.2. Use screws from underneath to x castors on.
Fit braked castor on front corner of unit.
4.2. Remove drawers
4.2.1. Push tab down on left side and push tab up on right
side, pull drawer from slides.
APMS58| Issue1- 15/04/16
Original Language Version
© Jack Sealey Limited
Refer to
Instructions
Fig.1

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
[e-mail]
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
APMS58| Issue1-15/04/16
Original Language Version
© Jack Sealey Limited