Sealey AP2513B.V3 User manual

INSTRUCTIONS FOR
TOPCHEST & ROLLCAB COMBINATION
13 DRAWER WITH BALL BEARING RUNNERS
MODEL NO: AP2513B.V3, AP22513BB.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this Topchest
& Rollcab combination.
9Locate the Topchest & Rollcab combination in a suitable working area.
9Keep the work area clean, uncluttered and ensure there is adequate lighting.
9Keep the Topchest & Rollcab combination clean and tidy in accordance with good workshop practice.
9Keep children and unauthorised persons away from the working area.
8DO NOT use the Topchest & Rollcab combination for any purpose other than that for which it is designed.
8DO NOT move the Topchest & Rollcab combination with drawers open.
8DO NOT open more than one drawer at the same time.
8DO NOT step on the drawers.
8DO NOT use in damp work areas.
WARNING! The warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator.
2. ASSEMBLY
AP2513B.V3, AP22513BB.V2| Issue 1 07/11/16
Original Language Version
© Jack Sealey Limited
1.
Lift the main rollcab body off
the base and topchest.
2.
Remove the 4 screws on
the bottom of the topchest
assembly, then remove the
base from the bottom of the
topchest.
3.
Reattach the base to the
bottom of the rollcab ensuring
it is the correct way up and
secure with the supplied
xings.

3. MAINTENANCE
3.1. Periodically lubricate castors and tighten all hardware.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
[e-mail]
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
4 & 5.
In each corner of the base attach the
castor and tighten the fixings.
6.
Attach the topchest side handles using the
2 x bolts. Insert the side handle into the
rollcab and attach using 4 x bolts and
washers.
Original Language Version
© Jack Sealey Limited AP2513B.V3, AP22513BB.V2| Issue 1 07/11/16