Sealey AK4403 User manual

INSTRUCTIONS FOR:
DOUBLE LEVER GREASE GUN
MODEL NO: AK4403
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
9Familiarise yourself with the application and the limitations of the grease gun, as well as the potential hazards.
9Keep the work area clean, uncluttered and ensure there is adequate lighting.
9Keep the grease gun clean for best and safest performance.
9Check moving parts alignment on a regular basis.
8DO NOT use the grease gun for any purpose other than that it was designed for.
8DO NOT operate the grease gun if any parts are damaged or missing, as this may cause failure and/or personal injury.
9When not in use store in a safe, dry, childproof location.
WARNING! Always wear approved eye protection when operating this gun.
2. INTRODUCTION
Robust, double arm grease gun with aluminium die-cast head. Uses screw type grease cartridges using vacuum suction to ensure full utilization
of grease cartridge as well as eliminating priming issues associated with conventional grease guns. Features a protective cap for hose storage
preventing contamination. 1/8” BSPT thread and supplied with adaptor to t most screw type cartridges on the market, including model numbers:
SCS107 & SCS108. Zinc plated lever handles with rubber ergonomic grips. Fitted with minimal wearing parts to ensure prolonged life and
supplied with 300mm (12”) delivery hose and 4-jaw coupler.
3. SPECIFICATION
Model no: ................................................................. AK4403
Delivery pressure: ......................................................7500psi
Delivery per stroke: ..................................................... 0.8cm²
4. OPERATION
4.1. Remove cap from cartridge and screw into grease gun body, (select grease gun cartridge adaptor as appropriate).
4.2. Work handles to displace air from delivery tube.
AK4403 | Issue 1 01/02/16
Original Language Version
© Jack Sealey Limited
Refer to
Instruction
Manual
Wear eye
Protection

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
[e-mail]
01284 757500
01284 703534
Web
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [e-mail] or telephone [phone].
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
AK4403 | Issue 1 01/02/16
Original Language Version
© Jack Sealey Limited