Sealey Sa892.v3 User manual

SA892.V3, SA893.V3, SA894, SA895 - 1 - 090704

INSTRUCTIONS FOR:

RETRACTING AIR HOSE REELS

Thank yo for p rchasing a Sealey prod ct. Man fact red to a high standard this prod ct will, if sed according to these instr ctions

and properly maintained, give yo years of tro ble free performance.

1. SAFETY INSTRUCTIONS

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.

USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE

DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

3Familiarise yo rself with the application and limitations of the air hose reel, as well as the specific hazards.

pWARNING! Disconnect the air hose reel from the air s pply before changing accessories, servicing or performing any maintenance.

3Maintain the air hose reel in good condition ( se an a thorised service agent).

3Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

3Locate and fix the air hose reel in a s itable working area. Do not position the hose in direct s n light, or in areas of extreme heat or

cold. Ens re there is adeq ate lighting.

pWARNING! Ens re maxim m air press re is not exceeded.

3Keep extended air hose away from heat, oil and sharp edges. Check hose for wear before each se, and ens re all connections are sec re.

3Keep the nwo nd air hose at a safe distance from the working area and free from wet, damp, oily s rfaces.

pWARNING! Always wear approved eye or face protection when operating the air hose reel.

3Maintain correct balance and footing. Ens re the floor is not slippery and wear non-slip shoes.

3Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery and contain and/or tie back long hair.

3Keep children and na thorised persons away from the working area.

7DO NOT operate the air hose reel if any parts are damaged or missing as this may ca se fail re and/or personal inj ry.

7DO NOT exceed the rated capacity of the air hose reel.

7DO NOT se the air hose reel for any p rpose other than that for which it is designed.

7DO NOT yank the hose from the air s pply.

7DO NOT operate the air hose reel when yo are tired or nder the infl ence of alcohol, dr gs or intoxicating medication.

7DO NOT direct air from the air hose at yo rself or others.

3When not in se ens re the air s pply is t rned off and tools disconnected. Disconnect from the air s pply and retract the hose into case.

pWARNING! DO NOT dismantle the hose reel casing. To do so may result in damage to the appliance and/or personal injury and will

invalidate the warranty. Internal maintenance, which will require the opening of the casing, must only be undertaken by an authorised

service agent.

MODEL NO. . . . . . . . . . . . . . . . . . .SA8 2.V3 . . . . . . . . . . . . . . . .SA8 3.V3 . . . . . . . . . . . . . . . .SA8 4 . . . . . . . . . . . . . . . . . . .SA8 5

Hose length . . . . . . . . . . . . . . . . . . . . . . .12m . . . . . . . . . . . . . . . . . . . . .9m . . . . . . . . . . . . . . . . . .15m . . . . . . . . . . . . . . . . . . . . .10m

Hose bore . . . . . . . . . . . . . . . . . . . . . . . .6mm . . . . . . . . . . . . . . . . . . .8mm . . . . . . . . . . . . . . . . . .8mm . . . . . . . . . . . . . . . . . . . .10mm

Maxim m press re . . . . . . . . . . . . . . . .150 psi . . . . . . . . . . . . . . . . . .150 psi . . . . . . . . . . . . . . . .150 psi . . . . . . . . . . . . . . . . . . .150 psi

Hose type . . . . . . . . . . . . . . . . . .Poly rethane . . . . . . . . . . . . . .Poly rethane . . . . . . . . . . .Poly rethane . . . . . . . . . . . . . .Poly rethane

Inlet - O tlet . . . . . . . . . . . . . . . . . . .1/4BSP . . . . . . . . . . . . . . . . .1/4BSP . . . . . . . . . . . . . . .1/4BSP . . . . . . . . . . . . . . . . . .3/8BSP

2. INTRODUCTION & SPECIFICATIONS

All models have a hard wearing composite casing with retracting air hose reel, ratchet and free-r nning operation enabling easy access to

locations within the extended air hose range. All reels can be wall or ceiling mo nted and come complete with attachment brackets.

SA892.V3, SA893.V3, SA894, SA895 - 1 - 090704

MODELS: SA8 2.V3 SA8 3.V3 SA8 4 SA8 5

3. MOUNTING/ASSEMBLY

WARNING! Ensure the hose is disconnected from the air supply. Do not position the hose in direct sun light or in areas of

extreme heat or cold.

3.1. To wall mo nt the reel first remove the wall mo nting bracket from the reel by releasing and withdrawing the two bracket pivots.

(Refer to items 11 on the parts diagram for the SA892.V3 & SA893.V3 and to items 7 on the parts diagram for SA894 & SA895.) To

release the pivots remove the casing screws which pass directly thro gh each pivot. ( The pivots for SA894 & SA895 are each

retained by two screws.)

pWARNING! DO NOT remove any other casing screws.

3.2. Fix the bracket in an appropriate position ens ring that the wall and the mo nting screws and pl gs will adeq ately s pport the

weight of the reel and the tension of the hose as it is p lled from the reel.

3.3. Re-attach the reel to the bracket ens ring that the pivots are correctly inserted and retained by the casing screws.

3.4. Ens re that the hose can be p lled o t to, and reeled back from, work sites witho t r bbing on the sides of the cable entry.

4.1. Extending the hose.

4.1.1. As the hose is p lled o t from the reel the action of the ratchet mechanism can be heard alternating between the s al clicking so nd and a

short period of silence. If the tension on the hose is released whilst the ratchet is clicking the hose will remain extended. If the tension on the

hose is released d ring silent operation the hose will retract. To stop the hose retracting p ll it o t again a little ntil yo hear the ratchet clicking.

4.2. Retracting the hose.

4.2.1. To release the hose and allow it to a tomatically rewind, p ll the hose o t from the locked position ntil the clicking stops and then release

the tension on the hose. Do not let go of the hose b t keep hold of it and g ide the end back to the reel.

pWARNING! The reel tension is factory set, if any adj stment is req ired contact an a thorised service agent. DO NOT remove any of

the black spring cover screws.

4. OPERATION

5. MAINTENANCE & STORAGE

6. PARTS LIST FOR SA8 4 & SA8 5

WARNING! Before attempting maintenance or inspection vent any pressure remaining in t e ose.

To ens re reliable operation, clean the hose and casing reg larly. DO NOT spray or wet the prod ct, b t clean with a cloth and warm water.

DO NOT se solvents or detergents, as these may permanently damage the item.

The hose reel does not req ire special maintenance as it is l bricated for life. If the prod ct needs to be opened, cons lt yo r nearest

a thorised service agent.

WARNING: DO NOT attempt to loosen, or remove, any casing screws yourself.

Replacement of the s pply hose sho ld be carried o t by skilled personnel only, cons lt yo r nearest a thorised service agent.

STORAGE:

Sho ld yo wish to store the air hose, ens re it is clean and dry. Place the item in a dark, safe, dry, childproof location, where the temperat re

will remain reasonably stable. DO NOT store in a nylon, or plastic, bag as this will enco rage condensation.

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.

IMPORTANT: No liability is accepted for incorrect se of this eq ipment.

WARRANTY: G arantee is 12 months from p rchase date, proof of which will be req ired for any claim.