Seizmik 26079 User manual

Installation & Operations Manual
Kubota 500 Windshield
Installation Information:
This product does not require any modifications
to your vehicle. Please familiarize yourself with all
the steps before beginning assembly.
Compatibility Info:
This windshield is designed to work with other
Seizmik branded Accessories for the Kubota 500
as well as OEM Kubota hard tops. Please note
Seizmik cannot guarantee fitment with other
branded aftermarket products. Please research
installation details on our products and others
when trying to combine different branded
accessories.
Seizmik makes Windshields, Mirrors, Door Kits,
Light Bars, Hood Racks, and other great
accessor ies for UTV’s to maximize the vehicles
usefulness. To help you do what you do better.
If you have any questions, comments, need
assistance, or are missing parts, please call 1-
866-838-3366 between 9:00AM and 5:00PM
EST. Or email us at [e-mail]. Visit
www.seizmik.com for more information on our
products.
1
Part Number 26079
Kit Contents:
1. Windshield
2. 4 8 ” 180 degree bulb bottom gasket
3. 1.5 small hole plastic Clamp (5)
4. 1 .2 5 ” Flange Bolt (3 )
5. Nyloc Flange Nut (3)
6. Knob (2)
7. Wingnut (2)
1
2
3
4
5
6
7

2
Installation:
1. Peel protective plastic back a few inches on both sides
of the bottom and clamp locations. You will remove this
completely after windshield installation is complete. Push
the 4 8 ” gasket on the bottom of the windshield.
2. Snap 3 1 .5 ” plastic clamps acr oss the fr ont
upper roll cage tube in the orientation shown.
3 . Snap the remaining 2 1 .5 ” plastic clamps on
each side of the roll cage in the location and
orientation shown 4. With the windshield flange facing towards the rear, bolt
the upper windshield to the 3 plastic clamps by placing it
BETW EEN the ears of the clamp, and fastening it with the
three bolts and nuts.
Windshield
4. Flex the windshield down against the roll cage. With the windshield against the outside face of the lower plastic
clamps, not between like the upper ones, fasten the windshield at the bottom using the threaded knobs and
wingnuts. When you need to access the under hood area, remove the wingnuts and knobs and the windshield will
rotate up on the upper clamps an allow you to open the hood.