Seizmik 76-10163 User manual

1
RANGER XP 1000 2 Seat Seizmik
Skid Plate Manual
Part # 76-10163
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully
follow the instructions in this manual and make no modifications.
If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM
and 5:00PM EST. You can email us at [email protected]

View looking up at the underside of the vehicle
2
Front
Rear

Parts List
Skid Plate Washer
M6 Clip Nut
Tapered Hex Screw M6x25mm
Skid Plate Insert Washer
3
76-10192
76-10193
76-10194
76-10195
76-10196
76-10197
76-10198
99-10006

ALL GREEN holes use M6x25mm tapered bolt and washer
into factory threaded holes.
YELLOW holes use M6x25mm tapered bolt and washer
into clip nuts unless called out otherwise.
ALL ORANGE holes use M6x35mm flange head bolt and
insert washer placed into factory hole in sheet metal.
4

Uses OEM Threaded holes
Bolts thread into clip nuts
Uses insert washer into sheet metal hole
5

Threading should face upwards, toward vehicle
Attach all clip nuts to specified holes in metal brackets.
6

Threading should face
upwards, toward vehicle
To start, remove stock skid plate.
Then, attach clip nuts to vehicle
undercarriage in locations shown
(Shown in YELLOW). Clip nut threads
should face upward, toward vehicle.
Place insert washers in Sheetmetal
holes in vehicle (Shown in ORANGE).
7
Side shown faces upwards,
toward vehicle

To start, loosely install the center 3 bolts and washers
(Shown in GREEN) so that the middle panel is held in
place on its own.
Next, attach the metal brackets to the middle panel
using 2 bolts and washers (shown in GREEN) and 2
bolts and washers (Shown in YELLOW) into the clip
nuts that you attached to the metal brackets. The
metal brackets go between the panels and the
vehicle frame. The panels will sandwich the brackets
to the underside of the vehicle frame.
8
Finish with these green holes
Begin with these green holes

M6x25mm Tapered Bolt
9

Clip Nut attaches directly to vehicle
Clip Nut attaches to metal bracket
10
M6x35mm Bolt with a clip nut attaching to vehicle
NOTE: Spacer goes
between vehicle
and rear panel

M6x35mm Bolt
11
NOTE: Spacer goes
between vehicle
and rear panel