Seizmik 76-10165 User manual

RZR XP 1000 2 Seat Seizmik
Skid Plate Manual
Part # 76-10165
1
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully
follow the instructions in this manual and make no modifications.
If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM
and 5:00PM EST. You can email us at [email protected]

View looking up at the underside of the vehicle
2
Front
Rear

Parts List
1.75” Wrap Around Clamp
Skid Plate Washer
M6 Clip Nut
Tapered Hex Screw M6x25mm
Skid Plate Insert Washer
3

GREEN holes use M6x25mm tapered bolt and washer
into factory threaded holes
YELLOW holes use M6x16mm bolt
and washer into clip nuts attached to metal brackets.
BLUE holes use M6x35mm with wrap around clamp
ORANGE holes use M6x25mm tapered bolt and
insert washer placed into factory hole in sheet metal
RED holes use Self Tapping Screws- Some locations
may or may not require pre-drilling of 1/8” pilot hole.
4

Uses insert washer into sheet metal hole
Uses Clamps
Self Tapping Screws-May or may not require predrilling of 1/8” pilot hole.
Uses OEM Threaded holes
16mm bolt threads into brackets with clip nuts
5

Uses insert washer into sheet metal hole
Uses Clamps
Self Tapping Screws-May or may not require predrilling of 1/8” pilot hole.
Uses OEM Threaded holes
16mm bolt threads into brackets with clip nuts
6

Attach all clip nuts on to slotted holes in metal brackets.
Threading should face upwards, toward vehicle
7

To start, remove stock skid plate.
Then, place insert washers (Shown in
ORANGE) into holes in Sheetmetal. Side
shown faces upwards, toward vehicle.
Snap clamps (Shown in BLUE) around
metal tubing in general location shown.
Threading should face inward.
8
1.75” Wrap Around Clamp
Insert Washer

To start, loosely install the center 3 bolts and washers
(Shown in RED) into pre-existing holes so that the
front panel is held in place on its own.
Next, loosely attach the metal brackets to the front
panel using 4 bolts and washers (Shown in YELLOW)
into the clip nuts that you attached to the metal
brackets. The metal brackets go between the panels
and the vehicle frame. The panels will sandwich the
brackets to the underside of the vehicle frame.
9
M6x16mm Bolt threads into Clip Nut
25mm Self Tapping Screw

M6x16mm Bolt
10

M6x25mm Tapered Bolt
11

1.75” Wrap Around Clamp
M6x35mm Bolt
M6x25mm Tapered Bolt and
Insert Washer
50mm Self Tapping Screw
12
NOTE: Spacer goes
between vehicle
and rear panel

25mm Self Tapping Screw
38mm Self Tapping Screw
13