Seizmik 25023 User manual

Installation & Operations Manual
Polaris Ranger FS/MS Profit
Full Vented Windshield
Installation Information:
This product does not require any modifications to your
vehicle. Please familiarize yourself with all the steps
before beginning assembly.
Compatibility Info:
This windshield is designed to work with other Seizmik
branded Accessories for the Polaris Pro-Fit Ranger as
well as OEM Polaris branded hard tops. Please note
Seizmik cannot guarantee fitment with other branded
aftermarket products. Please research installation
details on our products and others when trying to
combine different branded accessories.
Seizmik makes Windshields, Mirrors, Door Kits, Light
Bars, Hood Racks, and other great accessories for
UTV’s to maximize the vehicles usefulness. To help
you do what you do better.
If you have any questions, comments, need
assistance, or are missing parts, please call 1-866-
838-3366 between 9:00AM and 5:00PM EST. Or email
us at [email protected]. Visit www.seizmik.com
for more information on our products.
1
Part Numbers:
Full Size Polycarbonate #25023
Full Size Double Sided Hardcoated Polycarbonate #25024
Mid Size Polycarbonate #25025
Mid Size Double Sided Hardcoated Polycarbonate #25026
Kit Contents:
1
2
5
6
3
4
1. Bulb Gasket
2. Windshield With Vents
3. SZ Plastic Clamp (4)
4. Knob (4)
5. Bolt (4)
6. Backing Plate (4)

2
1. Peel plastic 4”back on all
sides of windshield. Remove
completely after windshield is
fully installed.
Gasket
2. Push the gasket on the windshield starting from the middle of the bottom edge. The bulb
should be on the inside of the windshield, the side of the windshield with the vent levers.
3. Your windshield should look
like this when you are finished
installing the gasket. 4. Open the clamp and place
around roll cage with the SZ logo
facing forward as shown.
5. Place four clamps in the approximate
locations shown.
8. Attach the windshield to clamp with bolt and
knob as shown above. Tighten knob to secure
windshield.
Turn handle to adjust vent. The vent has 3 positions: Closed, Defog, and open.
7. Line up holes in the backing plate
with holes in the windshield and insert.
The peg on the backing plate should
go in the inside holes (not the holes
near the edge of the windshield).
6. Place the windshield on the vehicle and
slide the clamps up and down to line up with
the holes on the sides of the windshield.
Installation:Installation:
VENT OPERATION: