Seizmik 18071 Quick start guide

1
Installation & Operations Manual for Pursuit Side View Mirror
Pursuit Mirror # 18071 & 18072
Contents:
Left Mirror and Clamp Assembly Right Mirror and Clamp Assembly Temporarily remove this socket head bolt using a 8mm
Allen Wrench
Installation:
Open clamp and place around roll
cage tube. Make sure the rubber
shim is in place in the thick half of
the clamp.
2. 3. 4.
Close clamp around roll cage
tube, put the bolt through the
hole, and place large rubber
washer over the end of the bolt.
Using the 8mm wrench,
screw the bolt into the
mirror but do not tighten
yet.
Rubber Shim
1.
Initial Adjustment:
Rotate mirror on clamp so that it is
level. When you are satisfied with
the location and angle, tighten
bolt.
Slide mirror up or down Roll Cage
tube to desired location.
12
3
The Mirror Housing has 3 detent positions.
Position 1 is for the drivers side, position 2
is passenger side, and position 3 is
completely folded. Once the detent position
is selected you can fine tune the viewing
angle by moving the mirror glass within the
housing.
For 1.75” Clamp Only!
Place the self adhesive thin
rubber shim in this location.

2
Repair and Maintenance
Replacing or Adjusting Mirror Glass
Tightening Mirror Housing Folding Feature
To tighten the folding feature of
the mirror, gently pry off the SZ
cap as shown and tighten nut.
If for any reason the Mirror Detent Insert ever becomes worn enough that
the mirror will not hold position well, please contact us for free
replacements. It can be replaced by first removing the nut shown in the
previous step. Next, remove the Mirror Housing, Spring, and Washer.
The Detent Insert can now be gently pried off and replaced. The detent is
designed so it can only go on one way.
Replacing Detent Insert
To replace or adjust Mirror Glass
pivot, gently pry off SEIZMIK cap
from the location shown.
1.
Tighten or loosen 8mm nut a little
at a time to adjust the mirror glass
ball joint tension, or remove it and
washers to replace Mirror Glass.
2.
Seizmik makes Windshields, Doors, Tops, Hood Racks, and other great accessories for utility vehicles & side x sides. Our products
are engineered tough for long life and tested under the harshest of conditions.
Seizmik products are designed, developed and manufactured by Vialink Corp. If you have any questions, comments, need
assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM and 5:00PM EST. You can email us at
[e-mail].
Pry here
Detent Insert