Seizmik 18011 User manual

Attach the Ranger Pro-Fit
mount to the header panel
flange as shown. Tighten
the M6x12mm button head
bolt to secure the bracket
and mirror to the header
panel. Install ball joint and
mirror onto clamp. Adjust
as necessary.
Use these bolts to adjust tension on the ball
joint. Clockwise turn will increase tension,
Counter-clockwise will decrease tension.
Parts List
A. Mirror Assembly
B. Round Tube Clamp
C. Pro-Fit Ranger Clamp
D. Can Am X3 Clamp
E. Can Am Defender Clamp (Back)
A
B
C D
Round Tube Clamp
Pro Fit Ranger Clamp X3 Clamp
Using the supplied M6x16mm button head
bolts, install the badge onto the X3 mirror
mounting plate facing the driver, and the
mirror ball joint arm facing toward the front of
the vehicle as shown in the images. Install ball
joint and mirror onto clamp. Adjust as
necessary.
Unbolt the ball joint arm from
the 2 clamp halves. Wrap the
clamp halves around the
tubing as shown and install
M5x30 bolt to secure the 2
halves together. Use the
remaining M5 bolts to attach
the ball joint arm to the
clamp halves. Install ball joint
and mirror onto clamp. Adjust
as necessary.
Can Am X3 18014
Round Tube Cages 18011, 18012 Pro-Fit Ranger 18013
Front of
Vehicle
Facing
Driver
M5x30
18011, 18012, 18013, 18014, 18015
Installation Manual

Hold up bracket to header
panel as shown and using
the hole in the top of the
bracket as a guide. Mark
and drill a .25” hole in the
header panel for the top
M6 button head bolt to go
through.
A
E
Defender Clamp
Can Am Defender 18015
18011, 18012, 18013, 18014, 18015
Installation Manual
Front of
Vehicle
Facing
Driver
Mark hole
Drill .25” hole
Parts List
A. Mirror Assembly
B. Round Tube Clamp
C. Pro-Fit Ranger Clamp
D. Can Am X3 Clamp
E. Can Am Defender Clamp (This Side)