Server Express 07392 User manual

Server Express®
Pumps
for purchasing our Server Express®Pump.
Express™ pouched condiment systems are sealed and
sanitary, achieve excellent evacuation and have only a
few parts for easy clean-up.
SIMPLIFY CONDIMENT MANAGEMENT— GO POUCHED
Thank You
MODELS:
07392
07398
Used with pouches up to
1½ gallons with 16mm tments.

Page 2
ASSEMBLY WASH ALL PARTS
PROPERLY BEFORE USE. See page 3.
Wrap loop
around lower
opening to
secure dome.
Lubricate with a small amount of clean water.
Rotate and position until both pegs on
housing t into holes on tube.
INSTALL TUBE
INSTALL DOME
2
3
Fittings are marked small,
medium or large on bottom.
SELECT DISCHARGE FITTING
5
into pump housing discharge tube.
Place loop of tting around peg on end of
discharge tube to secure.
INSERT DISCHARGE FITTING
6
Lubricate with a small amount of clean water.
Rotate and position until both pegs on
connector t into holes on tube.
Connector must point away from end of
discharge tube.
INSERT CONNECTOR
4
INSERT PINCH VALVE
1
into pump housing.
Press dome into
housing fully.
Ensure valve ap
covers bottom
opening.
TIP: Squeeze the pinch valve
open before installation to
ensure it isn’t stuck shut.
if applicable. Page 4 lists discharge tting
size(s) included with each pump model.
THIN (hot sauce)
THICK (ketchup or mustard)
THICKER (relish or tartar sauce)
CONSISTENCY OF
WHAT YOU DISPENSE SUGGESTED FITTING SIZE
SMALL
MEDIUM
LARGE

Page 3
CLEANING
RINSE fully with clear water.
3
SANITIZE
all parts according to local sanitization
requirements. All parts in contact with food
must be sanitized.
4
AIR DRY all parts fully.
5
Use dishwashing soap,
hot water
and nylon brush
YES!
• Dishwasher safe
• Do not use abrasive, caustic or ammonia
based cleansers.
• Do not use cleansing agents with high
concentrations of acid, alkaline or chlorine.
• Do not use metal scrapers or cleaning
pads that could scratch surfaces.
DISASSEMBLE & CLEAN
all washable parts with soap and hot water.
Use brush to clean any conned areas.
2
FLUSH & RINSE
all pump surfaces with hot water.
Place lower end of pump into container
of hot water and operate pump until all
remaining product is expelled and only hot
water is discharged.
1
SAFETY DISASSEMBLY
According to food and safety regulations, most foods
must be stored and/or served at certain temperatures
or they could become hazardous. Check with local food
and safety regulators for specic guidelines. Server
Products, Inc. cannot be responsible for the serving of
potentially hazardous product.
IMPORTANT
Clean, rinse, sanitize, and dry parts daily or regularly to
comply with local sanitization requirements.
NSF International lists this pump as:
“Not acceptable for dispensing
potentially hazardous foods.”
TIP: Squeeze the pinch valve
open before installation to
ensure it isn’t stuck shut.
TROUBLESHOOTING
• Ensure pinch valve is inserted in housing.
• Ensure connector is snapped fully in place to
tment in pouch.
• Ensure pump is properly installed in unit.
• Clean pump thoroughly.
PRODUCT DOESN’T PUMP?
• Wet parts with clean water to help t.
DIFFICULT TO ATTACH PARTS?
• Clean thoroughly. Food residue could prevent
a tight seal between dome and housing.
• Ensure dome edges are ush with housing.
DOME POPS OFF?

Page 4 Manual #EM_01758_RevD 020822
PART QTY DESCRIPTION
07089 1 7" TUBE
07798 1 LARGE PINCH VALVE
07381 1 CONNECTOR, 16MM
07388 1 PUMP HOUSING
DOME
PINCH VALVE
07798
PUMP HOUSING
07388
TUBE
07089
CONNECTOR
07381
DISCHARGE
FITTING
PUMP COMPONENT PART NUMBERS
DOME FOR MODELS 07392, 07398
07383 1
PUMP DOME, BLACK
DISCHARGE FITTINGS (VARIOUS SIZES)
07795 DISCHARGE FITTING, .156, SMALL
07796 DISCHARGE FITTING, .256, MEDIUM
07797 DISCHARGE FITTING, .394, LARGE
PUMP INCLUDED
MODEL DISCHARGE FITTING(S)
07392 MEDIUM & LARGE FITTINGS
07398 MEDIUM FITTING
SERVER PRODUCTS
LIMITED WARRANTY
This Server product is backed by a two-year
limited warranty against defects in materials and
workmanship. See Server-Products.com for details.
GENERAL SERVICE,
REPAIR OR RETURNS
Before sending an item to Server Products, contact
Customer Care to request a Return Authorization
Number. The RA Number ensures proper processing
and a prompt turnaround. Repaired units are typically
shipped out within 48 hours of receipt.
Merchandise returned for credit will incur a 20%
restocking charge, must be less than 90 days old, and in
unused (new) condition. Electrical parts (thermostats,
heating elements, etc.) are not returnable.
NEED HELP?
Please be prepared with the Part Numbers for your
items. Individual part numbers are listed above.
Chat with us!
[email protected]
262.628.5600 | 800.558.8722
Server Products Inc.
3601 Pleasant Hill Road
Richfield, WI 53076 USA