Server 07794 User manual

Server Express™
Pumps
...for purchasing our Server Express™ Pump.
Express™ pouched condiment systems are sealed
and sanitary, achieve excellent evacuation and have
only a few parts for easy clean-up.
SIMPLIFY CONDIMENT MANAGEMENT— GO POUCHED
Thank You
MODELS 07794 & 100264
Used with pouches up to
1½ gallons with 16mm fitments.

Page 2
ASSEMBLY WASH ALL PARTS
PROPERLY BEFORE USE. See page 3.
Wrap loop
around lower
opening to
secure dome.
Lubricate with a small amount of clean water.
Rotate and position until both pegs on
housing fit into holes on tube.
INSTALL TUBE
INSTALL DOME
2
3
Fittings are marked small,
medium or large on bottom.
SELECT DISCHARGE FITTING
5
into pump housing discharge tube.
Place loop of fitting around peg on end of
discharge tube to secure.
INSERT DISCHARGE FITTING
6
Lubricate with a small amount of clean water.
Rotate and position until both pegs on
connector fit into holes on tube.
Connector must point away from end of
discharge tube.
INSERT CONNECTOR
4
INSERT PINCH VALVE
1
into pump housing.
Press dome into
housing fully.
Ensure valve flap
covers bottom
opening.
TIP: Squeeze the pinch valve
open before installation to
ensure it isn’t stuck shut.
THIN (hot sauce)
THICK (ketchup or mustard)
THICKER (relish or tartar sauce)
CONSISTENCY OF
WHAT YOU DISPENSE
SUGGESTED
FITTING SIZE
SMALL
MEDIUM
LARGE

Page 3
CLEANING
RINSE
fully with clear water.
3
SANITIZE
all parts according to local sanitization
requirements. All parts in contact with food
must be sanitized.
4
AIR DRY
all parts fully.
5
Use dishwashing
soap, hot water
and nylon brush
YES!
• Dishwasher safe
• Do not use abrasive, caustic or ammonia
based cleansers.
• Do not use cleansing agents with high
concentrations of acid, alkaline or chlorine.
• Do not use metal scrapers or cleaning
pads that could scratch surfaces.
DISASSEMBLY
DISASSEMBLE & CLEAN
all washable parts with soap and hot water.
Use brush to clean any confined areas.
2
FLUSH & RINSE
all pump surfaces with hot water.
Place lower end of pump into container
of hot water and operate pump until all
remaining product is expelled and only hot
water is discharged.
1
SAFETY
According to food and safety regulations, most foods
must be stored and/or served at certain temperatures
or they could become hazardous. Check with local food
and safety regulators for specific guidelines. Server
Products, Inc. cannot be responsible for the serving
of potentially hazardous product.
IMPORTANT
Clean, rinse, sanitize, and dry parts daily or regularly
to comply with local sanitization requirements.
NSF International lists this pump as:
“Not acceptable for dispensing potentially
hazardous foods.”

Page 4 Manual #01671-RevF 072720
PART QTY DESCRIPTION
07089 1 7" TUBE
07798 1 LARGE PINCH VALVE
07383 1 PUMP DOME, BLACK (FOR 07794)
07381 1 CONNECTOR, 16MM
07388 1 PUMP HOUSING
07795 1 DISCHARGE FITTING, .156, SM.
07796 1 DISCHARGE FITTING, .256, MED.
07797 1 DISCHARGE FITTING, .394, LG.
TIP: Squeeze the pinch valve
open before installation to
ensure it isn’t stuck shut.
NEED HELP?
TROUBLESHOOTING
262.628.5600 | 800.558.8722
[email protected]
Server Products Inc.
3601 Pleasant Hill Road
Richfield, WI 53076 USA
GENERAL SERVICE,
REPAIR OR RETURNS
Before sending any item to Server Products for service,
repair, or return, contact Server Products customer
service to request a Return Authorization Number.
Merchandise must be sent to Server Products with this
number. Service is extremely prompt. Typically, units
are repaired and ship out within 48 hours of receipt.
Merchandise being returned for credit must be in new
and unused condition and not more than 90 days old
and will be subject to a 20% restocking charge.
SERVER PRODUCTS
LIMITED WARRANTY
• Ensure pinch valve is inserted in housing.
• Ensure connector is snapped fully in place to
fitment in pouch.
• Ensure pump is properly installed in unit.
• Clean pump thoroughly.
PRODUCT DOESN’T PUMP?
• Wet parts with clean water to help fit.
DIFFICULT TO ATTACH PARTS?
• Clean thoroughly. Food residue could prevent
a tight seal between dome and housing.
• Ensure dome edges are flush with housing.
DOME POPS OFF?
DOME
PINCH VALVE 07798
PUMP HOUSING
07388
TUBE
07089
CONNECTOR
07381
DISCHARGE
FITTING
07795,
07796,
or
07797
MODELS 07794 & 100264
Server Products equipment is backed by a
two-year limited warranty against defects in
materials and workmanship.
For complete warranty information go to:
www.Server-Products.com
Please be prepared with the Part Numbers for your
items. Individual part numbers are listed above.
07399 1 PUMP DOME, BLUE (FOR 100264)
07383 FOR 07794
07399 FOR 100264