Shad SH26 User manual

OWNERS MANUAL
Fig. B
1
2
2
3
4
5
6
1
SHAD Anchoring
7
4
5
6
Fig. A: (*) Place the TOP CASE bottom rack (1) in the assembly position(*) on the motorcycle original packet-
,
Fig. B on the SHAD anchoring:
Situate the bottom rack of the TOP CASE (1) in the assembly position, remove the fastening clips (2), fasten
with screws (7),the rectangular washers (4), the washers (5) and the nuts (6). Tighten all the screws and nuts.
Fig. A
Q.feR.soP
14211021
49401022
4)569NID04x6M(4414033
42/3170024
4)6Ø(0003035
4)6M(1202036
4)569NID03x6M(8504037
15211028
1. RACK D1B29PA
TOP CASE SH26/SH29/SH33

2.
8
ASSEMBLY INSTRUCCIONS
Once the adaptor has been assembled you are then ready to t the TOP CASE.
1- Put the key in and leave in the vertical
position. Slot the rear tongue into the adaptor groove. Fit the front anchorage
into its housing. WARNING. It is important to
ensure that the case is properly xed to the adaptor. Make sure you hear the click of the pin as it goes in and that the
front opening lever is correctly positioned (Fig. 3). 2- To open the TOP CASE, insert the key in the vertical position.
Operate the locking mechanism as shown in Fig. 4. Turning the key in a clockwise direction will lock the TOP CASE so
that it can neither be opened nor detached from the adaptor. The key can be removed in either the locked or unlocked
position. 3- To remove the TOP CASE, insert the key in the vertical position, hold the case by the handle, operate the
lower part of the opening mechanism and lift up gently until the anchorage comes out of the case. Then pull to remove
the upper tongue from the adaptor groove (Fig.5).
5.
3.
4.
The maximum load of the case is of 3 kg.
Then t the cover (8) by bending it slightly to insert the tongues (Fig. 2)

1 full face helmets
Waterproof Sealing System
Width: 40 / Height: 28.2 / Depth: 40.5
FEATURES
D1B29PAR plate included
Maximum Load: 3
Find out more about luggage systems & saddlebags we have.