Please prepare the following:
• Cushion (soft cloth, etc.)
• Tools (Phillips screwdriver)
Caution:
• If, due to insufficiently secure attachment or poor handling, the LCD monitor falls or is damaged in other similar
ways, please note that SHARP Corporation will not bear any responsibility.
Attachment
Before attaching the speaker system to the LCD monitor, please make sure to switch off the LCD monitor’s power
and disconnect the power plug from the outlet.
1Remove the back cover at the rear of the LCD display unit.
2Remove the screws at the rear of the LCD display unit.
Back cover
Please protect it with a cushion
or a similarly soft cloth to
protect the display against
damage.
Remove the (four) screws
Rear cover
Rear cover
Speaker system
Supplied speaker system fixing screws
Weight
Approx. 3.5 kg
Approx. 13.3 kg
(LCD display unit)
Approx. 3.5 kg
(AVC system)
Back cover
Cable clamps
Please insert
3Install the speaker system.
• Never insert the speaker system fixing screws in the provided holes without attaching the speakers. If inserted
without the speakers, they will damage the internal parts. Therefore, only insert the supplied speaker system
fixing screws when installing the speaker system.
4Attach the cables and re-attach the back cover at the rear of the LCD display
unit.
• The cords are fixed using the cable clamps.
Precautions when transporting the LCD display unit
■When transporting the display, never carry it by holding onto the speakers. Be sure to always carry the display
by holding it with two hands – one hand on each side of the display.
Display (rear panel)
– 2 – – 3 –
Item Name
Speaker system AN-28SP2
LCD monitor LC-28HM2
