Siemens SITRANS FUP1010 User manual

JASPER ENGINEERING & EQUIPMENT
800-776-6184
www.jaspereng.com
[email protected]
Proudly Serving Customers since 1958
Siemens SITRANS FUP1010
Quick Start Part One:
Instrument Setup
1.
Power On Instrument
Press ON/OFF utton. Display will show the
WELCOME splash screen:
2
.
Enter FastStart Setup Mode
Press MENU. Display will show the following:
Press RIGHT ARROW twice to select Single
Channel. Display will show the following:
[x2]
Press RIGHT ARROW twice to select Clamp-on.
Display will show the following:
[x2]
Press RIGHT ARROW once to enter FastStart
Setup.
3
.
Input Pipe D
ata
Press RIGHT ARROW to open pipe material
selection. Use UP and DOWN arrows to select
appropriate material and press ENTER to confirm:
Press RIGHT ARROW to open pipe size selection.
Use UP and DOWN arrows to select appropriate
pipe size/ schedule and press ENTER to confirm:
Press RIGHT ARROW next to Install Sensor to
enter Sensor Installation Mode.
4. Select Transducers
From Sensor Installation Mode, press DOWN
ARROW once to select Sensor Size. Based on
entries in [3], the FUP1010 will recommend
transducers. This will e shown on the second line
from the top:
Press RIGHT ARROW to open sensor selection. Use
UP and DOWN arrows to select appropriate
sensor ased on recommendation and inventory.
Press ENTER to confirm selection.
Screen will now populate with sensor spacing, mode, offset,
track type, and linear value. Use Num er Offset and Sensor
Size information to physically install transducers on pipe:
Follow instructions on reverse to install transducers.

JASPER ENGINEERING & EQUIPMENT
800-776-6184
www.jaspereng.com
[email protected]
Proudly Serving Customers since 1958
Siemens SITRANS FUP1010
Quick Start Part Two:
Transducer Setup
5. Prepare Transducers
Retrieve appropriate transducers from case ased on Sensor
Size entry in [4]. Make sure serial num ers match, ending in A
and B:
Unscrew thum screws from spacer ar and use to space
sensors ased on Spacing Offset from [4]. Sensor BNC ca le
ports should face away from each other:
Apply a generous line of ultrasonic coupling compound to the
ottom of each transducer:
6
. Prepare
Pipe
Pipe must e clean and free of rust, loose paint, and other
contaminants. Use supplied a rasive sponge to clean surface
prior to installation. Note that severely rusted pipes may
need to e cleaned with a powered a rasive tool. Cast iron
pipe may need surface smoothed out.
7
.
Mount Transducers
and Ca les
Insert supplied clamps through transducer mounting slots
and around pipe. Tighten using a 5/16” hex driver, ensuring
that transducer mounting frame is parallel to pipe and
transducers are square:
Install supplied 20’ ca les onto transducers. BNC connectors
use a collar that must e pressed on and rotated to secure.
Ca les are marked UP and DN for upstream and downstream
sensors:
Insert transducer ca le connector into FLOW SENSOR port on
rear of FUP1010. Connector is polarized and will only fit one
way. As with BNC ca les, collar rotates to secure:
7
.
Complete Installation
On FUP1010 install menu from [4], use DOWN ARROW to
select Install Complete. Press RIGHT ARROW to pop up menu
and press DOWN ARROW to select INSTALL. Press ENTER.
System will run through makeup routine for several minutes.
When meter provides sonic velocity, press MENU. Press LEFT
ARROW to return to flow screen.