Siemens TA6JG20 User manual

806941A03
s
Power Distribution Connectors
Conectores de Distribución de Energía
Connecteurs de distribution de puissance
1 / 3
Installation Instructions / Instructivo de Instalación
For Use With Frame JG
Para Usar Con Caja Base JG
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse. Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse. Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Use only with Siemens certified Components.
Utilizar únicamente con componentes certificados de Siemens.
A utiliser uniquement avec les composants certifiés Siemens.
3VL9402-4TP01
3VL9402-4TP31
3VL9404-4TP01
3VL9404-4TP31
Item: TA6JG20
3TA6JG20
TA12JG04
3TA12JG04
U.S. Cat. No. Euro Order No.
I.L. No. 806941A03
1/8”
3/16”
Cal. ISO 6789 6mm
Special Purpose - Not for general use when
used with connectors below:
Proposito Especial - No para uso general
cuando es usado con conectores debajo:
s
WARNING
3TA6JG20 / 3VL9402-
4TP31
3 X - M8 x 30mm
3 X
3
X
TA6JG20 / 3VL9402-4TP01
1 X - M8 x 30mm
1 X
1
X
NOTE - These instructions do not purport to cover all details or variations in equipment, or to provide for every possible
contingency to be met in connection with installation, operation or maintenance. Should further information be desired or
should particular problems arise, which are not covered sufficiently for the purchaser’s purposes, the matter should be
referred to the local Siemens sales office. The contents of this instruction manual shall not become part of or modify any
prior or existing agreement, commitment or relationship. The sales contract contains the entire obligation of Siemens. The
warranty contained in the contract between the parties is the sole warranty of Siemens. Any statements contained herein
do not create new warranties or modify the existing warranty.
Trademarks - Unless otherwise noted, all names identified by ® are registered trademarks of Siemens AG or Siemens
Industry, Inc. The remaining trademarks in this publication may be trademarks whose use by third parties for their own
purposes could violate the rights of the owner.

2 / 3 806941A03
2
6
1
7
clic
4
3
11lb. in.
[ 1.2 Nm ]
5
Note: Load Side Only
Nota: Carga Solamentez
M8 x 30mm
133 lb. in.
[ 15 Nm ]
6mm
Trip
[ Interrumpir ]
s
WARNING
1 X - M8 x 30mm
1 X
1 X
TA12JG04 / 3VL9404-4TP01
3 X
3 X
3TA12JG04 / 3VL9404-4TP31
3 X - M8 x 30mm

8
3 / 3
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse. Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse. Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
B
A
CC
B
A
1/8”
3/16”
TA6JG20 3VL9402-4TP01
3TA6JG20 3VL9402-4TP31 TA12JG04 3VL9404-4TP01
3TA12JG04 3VL9404-4TP31
For Support in Europe refer to :
Bestell-Nr. / Order No.: 3ZX1012-0VL68-2BA1 Internet: www.siemens.de/lowvoltage/technical-assistance GWA 4NEB 179 6941-10 DS 04
806941A03
19
7
8 AWG
[ 6 mm2]
40 lb. in [ 4.5 Nm ]
Cu
14 – 4 AWG
[ 2.5 – 16 mm² ]
Al
8 – 4 AWG
[ 10 – 16 mm² ]
Cu / Al
14 – 2 AWG
[ 2.5 – 35 mm² ]
Wire Strip Length
[ Quitar ]
Wire Connector
[ Conexión del
cable ]
C
60°C and 75°C
Wire Size
[ Rango Cable ]
Torque
[ Esfuerzo de
torsión ]
A
UL 486A - 486B
Req. Wire Stranding
( Cable ) CU
Class
C
CU / AL
Class
BB
TA6JG20
3TA6JG20
3VL9402-4TP01
3VL9402-4TP31
TA12JG04
3TA12JG04
3VL9404-4TP01
3VL9404-4TP31
6 – 2/0 AWG
[ 16 – 50 mm2]
120 lb. in. [ 14 Nm ]
14 – 10 AWG
[ 2.5 - 4 mm2]
35 lb. in. [ 4 Nm ]
197
37
19
Cu / Al
1 – 2/0 AWG
[ 50 mm² ]
14 - 8 AWG
[ 2.5 – 6 mm2]
35 lb. in.
[ 4 Nm ]
6 - 4 AWG
[ 10 – 16mm2]
50 lb. in.
[ 5.6 Nm ]
.50 - .62
[ 13 – 15mm ] 1.00 – 1.13 [ 25 - 28mm ] 1.62 – 1.75
[ 41 - 44mm ]
.57 - .69
[ 15 – 17mm ] 1.12 – 1.25 [ 28 - 32mm ] 1.25 – 1.38
[ 32 - 35mm ]
Subject to change without prior notice © Siemens Industry Inc. 2010
Siemens Industry, Inc. , Norcross, GA 30092 U.S.A.
Technical Support: Toll Free: 1-800-241-4453 Internet: www.usa.siemens.com/powerdistribution