Sierra Wireless LS300 User manual

AirLink®LS300 Quick Start Guide
Page 1
© 2013 Sierra Wireless All Rights Reserved PN 2400272 Rev. 1
This guide provides instructions for quickly getting your Sierra Wireless®LS300 device congured and connected.
For more information refer to the:
• AirLink LS300 User Guide
• ALEOS™Conguration User Guide
Both are available for download from the Sierra Wireless web site (www.sierrawireless.com/Support/Downloads).
1 Remove the rear panel access cover.
2 Slide the SIM card into the SIM card holder.
Note the location of the notched corner for correct alignment.
3 Re-attach the cover.
STEP 1 Install the SIM Card (Does Not Apply to CDMA Devices)
STEP 2 Connect and Turn On the Device
1 Connect the RF antenna. 2 If required, connect the GPS and/or the diversity antenna (recommended).
3 If required by your application,
connect the RS-232 port and/or the
USB port.
4 Connect a Windows®computer to the device with an Ethernet cable.
5 Connect the power cable to the device.
The device starts automatically, as indicated by the ashing LEDs.
NOTE: If you want to congure all your devices at the same time using AirVantage®Management Service, follow the instructions on page 2 to
register your devices before applying power.

AirLink®LS300 Quick Start Guide
AirLink Support
suppor[email protected]
AirLink Online Support Knowledgebase
www.sierrawireless.com/Support/SupportCenter
AirLink Software Downloads
www.sierrawireless.com/Support/Downloads
Sierra Wireless Contact Information
Sierra Wireless Headquarters
13811 Wireless Way, Richmond, BC, Canada, V6V 3A4
Main Phone: [phone] (8am to 5pm Pacic time)
Page 2
AirVantage Management Service Sales
[e-mail]
AirLink Hardware Sales
[email protected]
Connect to ACEmanager™
Connect to AirVantage Management Service
1 On a Windows computer connected to the LS300, enter http://192 .168.13.31:9191 in the web browser.
The ACEmanager login screen appears.
NOTE: It may take the device 2 – 3 minutes to respond after the initial power up.
2The administrator user name, user, is entered by default. Enter the default password 12345.
3The ACEmanager homepage appears. You can now congure each device with ACEmanager.
Refer to the ALEOS Conguration User Guide for detailed information.
1 Using a web browser, log into your AirVantage Management Service account.
If you don’t have an AirVantage account, you can get a free trial account at
https://airvantage.net.
2 If you have not already done so, register your devices by following the instructions on the registration page.
3Apply power to all your devices. AirVantage Management Service completes the registration at the next device
check in (default device check in is every 24 hours).
4You can remotely congure and monitor all your devices at the same time using AirVantage Management Service.
© 2013 Sierra Wireless All Rights Reserved PN 2400272 Rev. 1