Signature Hardware FERGUSON CORNER SHOWER TRAY User manual

1Ferguson Corner Shower Tray Installation Instructions
FERGUSON CORNER SHOWER TRAY
INSTALLATION INSTRUCTIONS
Before you begin, review the instructions below carefully. Observe all
local plumbing and building codes when installing the shower tray.
Unpack and inspect the shower tray and parts for damage. If damage
is found, please call customer service at 1-866-855-2284. If you need
assistance while installing your shower tray, contact customer service.
Signature Hardware accepts no liability for any damage to oor, walls,
plumbing, etc., or for personal injury during installation. We recommend
consulting a professional if you are unfamiliar with installing bathroom
xtures and plumbing.
TOOLS AND MATERIALS:
Silicone Sealant Level Drill
Tape Measure Hammer Pencil
Screwdriver
12”
12”
INSTALLATION:
1. To accommodate plumbing, prepare your oor as specied in drawing below. A 2" drain pipe should project ½" above
the oor line. We recommend measuring your shower tray for nal dimensions.

2Ferguson Corner Shower Tray Installation Instructions
2. Position the tray to verify that the drain pipe location matches the actual location of the drain. Remove the tray and
make any necessary adjustments.
3. Install your drain according to the Drain Installation Instructions (drain not included).
4. Pour oor leveling compound evenly over the entire installation area and spread with a trowel.
5. Lower the shower tray over the center of the drain pipe and set into place. Apply pressure to ensure that the
compound is in contact with the entire bottom surface of the tray.
6. Verify that the tray is level and adjust as necessary.

3Ferguson Corner Shower Tray Installation Instructions
7. Once the drain is connected, plug the drain and ll the base with a small amount of water.
8. Check for any leakage around the drain (some bubbles may appear) and below (if access is available).
9. Unplug the drain and assure that the drainage is efcient. There should be no water puddling in the tray.
10. Drill pilot holes and attach the shower tray to the wall with 1-¼ " stainless steel screws.
11. Run a bead of silicone sealant along the top and base of the shower tray. Allow sealant to dry 24 hours before use.