Silvercrest SFKS 2 A1 User manual

WIRELESS PLUG-IN DOORBELL SFKS 2 A1
IAN 271729
TRÅDLÖS DÖRRKLOCKA
FÖR VÄGGUTTAGET
Bruksanvisning
DRAADLOZE DEURBEL
VOOR HET STOPCONTACT
Gebruiksaanwijzing
PISTORASIAAN KYTKETTÄVÄ
LANGATON OVIKELLO
Käyttöohje
FUNKTÜRKLINGEL FÜR
DIE STECKDOSE
Bedienungsanleitung
WIRELESS PLUG-IN
DOORBELL
Operating instructions
CARILLON SANS FIL
ENFICHABLE
Mode d'emploi

GB/IE Operating instructions Page 1
FI Käyttöohje Sivu 25
SE Bruksanvisning Sidan 49
FR/BE Mode d’emploi Page 73
NL/BE Gebruiksaanwijzing Pagina 97
DE/AT/CH Bedienungsanleitung Seite 121
Before reading, unfold the page containing the illustrations and
familiarise yourself with all functions of the device.
Käännä ennen lukemista kuvallinen sivu esiin ja tutustu seuraa-
vaksi laitteen kaikkiin toimintoihin.
Vik ut bildsidan och ha den till hands när du läser igenom anvisning-
arna och gör dig bekant med apparatens/maskinens funktioner.
Avant de lire le mode d'emploi, ouvrez la page contenant les
illustrations et familiarisez-vous ensuite avec toutes les fonctions
de l'appareil.
Vouw vóór het lezen de pagina met de afbeeldingen open en
maak u vertrouwd met alle functies van het apparaat.
Klappen Sie vor dem Lesen die Seite mit den Abbildungen aus
und machen Sie sich anschließend mit allen Funktionen des
Gerätes vertraut.

A
C
B
5x 2x 2x

1
SFKS 2 A1
GB
IE
Contents
Introduction ........2
Copyright .............2
Limitation of liability .....2
Intended use ...........3
Warnings used .........4
Safety.............5
Basic safety guidelines . . .5
Descriptions of
components ........9
Operation ....... 10
Check the package
contents .............10
Disposal of packaging
materials .............11
Power supply: receiver . .11
Inserting/replacing the
batteries .............11
Handling and
operation ........ 13
Selecting the signal type.13
Adjusting the signal sound
volume...............13
Selecting the ringer melody 14
Synchronising the sender
and receiver ..........14
Mounting the transmitter 15
Maintenance ..... 17
Troubleshooting . . 17
Cleaning ......... 18
Storage when not
inuse ........... 19
Disposal ......... 19
Disposal of the appliance 19
Disposal of batteries ....20
Appendix ........ 21
Technical data.........21
Notes on the Declaration
of Conformity .........21
Warranty.............22
Service ..............23
Importer .............24

GB
IE
2SFKS 2 A1
Introduction
Congratulations on the purchase of your new appliance.
You have selected a high-quality product. The operating
instructions are part of this product. They contain important
information on safety, usage and disposal. Before using
the product, familiarise yourself with all handling and
safety guidelines. Use the product only as described
and for the range of applications specified. Keep these
operating instructions in a safe place. Please also pass
these operating instructions on to any future owner.
Copyright
This documentation is protected by copyright.
Any copying or reproduction, including in the form
of extracts, or any reproduction of images (even in a
modified state), is permitted only with the written
authorisation of the manufacturer.
Limitation of liability
All the technical information, data and instructions regard-
ing installation, connection and operation contained in
these operating instructions corresponds to the latest infor-
mation available to us at the time of printing and takes
our previous experience and know-how into account.

3
SFKS 2 A1
GB
IE
No claims may be derived from the specifications, figures
and descriptions in these operating instructions.
The manufacturer assumes no responsibility for damage
caused by failure to observe these instructions, improper
use, incompetent repairs, making unauthorised modifica-
tions or for using unapproved replacement parts.
Intended use
This appliance serves as a wireless doorbell system to
announce visitors, allowing for the operation of a door
bell without any wiring. The appliance is not intended
for any other purpose, nor for use beyond the scope
described. The appliance is not intended for use in
commercial or industrial environments. The manufacturer
accepts no responsibility for damage caused by failure
to observe these instructions, improper use or repairs,
unauthorised modifications or the use of unapproved
replacement parts. The risk shall be borne solely by the user.

GB
IE
4SFKS 2 A1
Warnings used
The following warning notice types are used in these
operating instructions:
DANGER
A warning notice at this hazard level indi-
cates an imminently hazardous situation.
If the hazardous situation is not avoided, it could
result in death or serious physical injury.
► Follow the instructions in this warning notice to
avoid the risk of death or serious injury.
CAUTION!
A warning notice at this hazard level indi-
cates a potential for property damage.
Failure to avoid this situation could result in property
damage.
► Follow the instructions in this warning notice to
prevent property damage.
NOTE
► A note provides additional information that will
assist you in using the appliance.

5
SFKS 2 A1
GB
IE
Safety
This section contains important safety instructions for using
the appliance. This appliance complies with statutory
safety regulations. Improper use may result in personal
injury and property damage.
Basic safety guidelines
■ This appliance may be used by children aged
8 years and above and by persons with limited phys-
ical, sensory or mental capabilities, or lack of experi-
ence and knowledge, provided that they are under
supervision or have been told how to use the appliance
safely and are aware of the potential risks. Children
must not use the appliance as a plaything. Cleaning
and user maintenance tasks may not be carried out
by children unless they are supervised.
■ Pull out the plug to disconnect the appliance from the
mains electricity. Ensure that access to the plug is not
obstructed.
■ Risk of explosion if the battery is replaced incorrectly.
Replace only with the same or equivalent type.
■ Do not place any sources of naked flames, such as
lighted candles, on the appliance.

GB
IE
6SFKS 2 A1
■ Check the appliance for visible external damage
before use. Do not operate an appliance that has
been damaged or dropped.
■ Do not expose the appliance to direct sunlight or
high temperatures. Otherwise it may overheat and
be irreparably damaged.
■ Do not expose the receiver to water spray or drips,
and do not place liquid-filled objects such as vases
or open drink containers on or near the receiver.
■ Warning: electrical voltage!
Never open the housing of the receiver. There are
no user-serviceable or replaceable components inside
the appliance.
■ Do not make any unauthorised modifications or
alterations to the appliance.
■ All repairs must be carried out by authorised special-
ist companies or by the Customer Service department.
Improper repairs may put the user at risk. It will also
invalidate any warranty claims.
■ Unplug the appliance immediately if you smell burning
or notice smoke. Have the appliance checked by a
qualified specialist before using it again.

7
SFKS 2 A1
GB
IE
DANGER
Mishandling the batteries can cause fires,
explosions, leakages or other hazards!
In order to handle batteries safely, please
observe the following safety instructions:
► Do not throw the batteries into a fire and do not
subject them to high temperatures.
► Do not open, deform or short-circuit batteries,
since this can lead to chemical leakage.
► Do not attempt to recharge the batteries.
► Check the condition of the batteries at regular inter-
vals. Leaking chemicals can cause permanent dam-
age to the appliance. Take particular care when
handling damaged or leaking batteries.
Risk of acid burns! Wear protective gloves.
► Chemicals that leak from a battery can cause skin
irritation. In the event of contact with the skin, rinse
with plenty of water. If the chemicals come into
contact with your eyes, rinse thoroughly with water,
do not rub and consult a doctor immediately.

GB
IE
8SFKS 2 A1
DANGER
► Keep batteries out of the reach of children.
Children might put batteries into their mouth and
swallow them. If a battery has been swallowed,
seek medical assistance IMMEDIATELY.
► Always insert the batteries the right way round
(observe correct polarity) otherwise there is a
danger that they could explode.
► If you do not intend to use the appliance for a
long time, remove the batteries.
► Do not ingest the battery – there is a risk of chemi-
cal burns!
► This product contains a button cell battery. Swal-
lowing the button cell battery can cause severe in-
ternal burns in just 2 hours and can lead to death.
► Keep new and old batteries away from children.
► If the battery compartment does not close securely,
stop using the product and keep it away from children.
DANGER
Do not allow children to play with the packaging
material! Keep all packaging materials out of the
reach of children. Risk of suffocation!

9
SFKS 2 A1
GB
IE
Descriptions of components
(See fold-out page for illustrations)
Receiver (Fig. A)
Speaker
Signal display
Signal type switch (optical/acoustic)
Volume button (VOL 1/2/3)
Melody selection button
Synchronisation button
Sender (Fig. B)
Nameplate cover
Ringer button
Battery compartment
Mounting plate
-Mounting holes
Accessories (Fig. C)
3Double-sided adhesive tape
!Name plate
.Wall plug
0Screw
63V battery, type CR2032
1Unlocking tool

GB
IE
10 SFKS 2 A1
Operation
Check the package contents
(See fold-out page for illustrations)
The scope of delivery includes the following components:
● 1 x receiver
● 1 x sender
● 1 x 3V battery, type CR2032
● 5 x name plates
● 2 x wall plugs with screws for sender assembly
● 1 x double-sided adhesive tape
● 1 x unlocking tool for the mounting plate for the
transmitter housing
● These operating instructions
♦ Remove all parts of the appliance from the packag-
ing and remove all packaging materials.
♦ Check the package for completeness and for signs of
visible damage.
♦ If the delivery is incomplete or damage has occurred
as a result of defective packaging or during trans-
port, contact the Service hotline (see chapter entitled
Service).

11
SFKS 2 A1
GB
IE
Disposal of packaging materials
The packaging protects the appliance from damage
during transport. The packaging materials have been
selected for their environmental friendliness and ease
of disposal, and are therefore recyclable.
Returning the packaging into the material
cycle conserves raw materials and reduces
the amount of waste generated.
Dispose of packaging materials that are no longer
needed in accordance with applicable local regulations.
Power supply: receiver
The receiver is plugged into a properly installed mains
power outlet and does not require batteries.
Inserting/replacing the batteries
♦ Insert the unlocking tool 1into the recess on the side
of the transmitter and turn it to the side to remove the
mounting plate (see Fig. 1).
♦ Insert a 3V battery, type CR 2032, into the battery
compartment . The side of the battery marked with
a “+” must be facing upwards.

GB
IE
12 SFKS 2 A1
♦ Replace the mounting plate on the transmitter and
click it audibly into place (see Fig. 2). Ensure that the
sealing ring is properly inserted into the frame of
the mounting plate. Otherwise, IP protection is not
provided.
Fig. 1 Fig. 2
NOTE
► If the performance of appliance reduces or com-
pletely stops, it means the battery is exhausted.
Replace the used battery with a new one of the
same type.

13
SFKS 2 A1
GB
IE
Handling and operation
Selecting the signal type
The receiver can indicate the reception of a door-ring
signal either optically, acoustically, or optically and
acoustically.
♦ To select, move the signal type switch to the
desired position:
— acoustic ringer signal only, the selected
melody will be played
— optical ringer signal only, the signal display
flashes
— optical and acoustic ringer signal
Adjusting the signal sound volume
Press the VOL. 1/2/3 button  repeatedly until the
desired volume is set.
Loud Medium Quiet

GB
IE
14 SFKS 2 A1
Selecting the ringer melody
There are 36 different ringer melodies stored in the
appliance.
♦ Press the melody select button .
♦ Stop the selection when you hear the desired melody.
The appliance will use the last-played melody.
Synchronising the sender and receiver
The transmitter and receiver of this wireless doorbell
system can communicate with each other via a number
of different codings. This means that you can operate up
to 5 transmitters with one receiver. In addition, you can
extend the wireless doorbell system with any number of
receivers. This is only possible if the sender and receiver
within a system are working on the same frequency,
however. For this, you must synchronise the appliances
as follows:
♦ Press the synchronisation button on the
receiver.
♦ Now press the ringer button on the transmitter.
If the synchronisation has been a success, the receiver
notifies you of the programmed call signal. Should the
receiver not react as described, repeat the synchronisation.

15
SFKS 2 A1
GB
IE
Mounting the transmitter
♦ Select a suitable positioning for the sender, close to
your outer door.
♦ Pierce the pre-stamped mounting holes -on the inner
side of the mounting plate with a pointed object.
♦ Mark the positions for the required drill holes with
the help of the mounting plate and drill the holes
for the supplied wall plugs .(6mm drill).
♦ Push the wall plugs into the drill holes and screw the
mounting plate onto the wall using the screws 0
(see Fig. 3).
♦ Push the transmitter onto the mounting plate until
it clicks audibly into place.

0
.
Fig. 3

GB
IE
16 SFKS 2 A1
NOTE
► Alternatively, you can mount the transmitter onto a
suitable surface using the double-sided adhesive
tape 3.
♦ Label one of the supplied name plates !. If you
label the name plate by hand, make sure you use a
waterproof pen.
♦ Remove the name plate cover from the transmitter
and insert your name plate into the recess on the
transmitter.
♦ Replace the name plate cover on the transmitter.

17
SFKS 2 A1
GB
IE
Maintenance
The appliance is maintenance-free. No form of main-
tenance, either on or in the appliance, is intended for
execution by the user. In the event of malfunction or
apparent damage, contact Customer Services. If the
appliance is not going to be used for an extended
period, remove the batteries.
Troubleshooting
There is no ring when pressing the ringer button
♦ Check whether there is a battery (type CR2032) in
the transmitter.
♦ Check whether the power outlet being used for the
receiver is working properly.
♦ It is possible that the transmitter is not synchronised
with the receiver. Repeat the synchronisation.
♦ Ensure that the signal type switch is set to the
position or .
The range is reduced
♦ A weak battery will reduce the range. Change the
battery every 12–18 months.