Silvercrest TQCS 10 A1 User manual

IAN 387741_2101 IAN 387741_2101
WIRELESS INDUCTIVE QI®CHARGING STATION
Operation and Safety Notes
ESTACI N DE CARGA INDUCTIVA QI®
Instrucciones de utilización y de seguridad
INDUCTIVE QI®CHARGING STATION /
ESTACIÓN DE CARGA INDUCTIVA QI®
TQCS 10 A1
Distributed by/Distribuido por:
LIDL US, LLC, Arlington, VA 22202
Model No./Modelo Núm.:
HG08307A-US, HG08307B-US
Version/Versión: 07/2021
Made in/Hecho en: China

US-EN
Operation and Safety Notes Page 3
US-ES
Instrucciones de utilización y de seguridad Página 24

3
US-EN
Description of signal words .................................... Page 4
Customer service......................................................... Page 4
Introduction ................................................................... Page 5
Intended use.................................................................. Page 5
Trademark notices...................................................... Page 6
Important safety instructions................................ Page 6
Description of parts ................................................... Page 12
Technical data .............................................................. Page 14
Scope of delivery ........................................................ Page 15
Before use ...................................................................... Page 15
Operation....................................................................... Page 16
Troubleshooting........................................................... Page 18
Storage when not in use .......................................... Page 19
Cleaning .......................................................................... Page 20
Disposal........................................................................... Page 20
Three year limited warranty.................................. Page 21

4 US-EN
DESCRIPTION OF SIGNAL WORDS
WARNING indicates a hazardous situation that, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazardous situation that, if not avoided,
could result in minor or moderate injury.
NOTICE indicates information considered important, but not
hazard related (e.g. messages related to property damage).
CUSTOMER SERVICE
Visit a LIDL store for further assistance.
Please have your IAN number ready.
Call customer service at 1 [phone]
Visit the Website Customer Service Platform at
www.lidl.com/contact-us
IAN 387741_2101

5
US-EN
INDUCTIVE QI®CHARGING STATION
PIntroduction
Congratulations on your purchase. You have selected a quality
product. The instructions for use are a part of the product. They
contain important information about the safety, use and disposal
of the product. Before using the product, please learn about all the
safety information and usage instructions. Only use the product as
described and for the specified applications. If you lend the product
to someone else, please also give all the instructions.
PIntended use
The INDUCTIVE QI®CHARGING STATION (hereinafter referred
to as the “Product“) is an information electronics device. This
product is only for charging mobile devices that use Qi technology.
Other devices cannot be charged with the product. The product
is intended for private use only and not for commercial use.
The manufacturer accepts no liability for damage resulting from
unauthorised modifications or improper use.

6 US-EN
PTrademark notices
 USB®is a registered trademark of USB Implementers Forum, Inc.
 “Qi“ and the Qi logo mark are trademark of the Wireless Power
Consortium (WPC).
 The TRONIC trademark and trade name is the property of their
respective owners.
 Any other names and products are trademarks or registered
trademarks of their respective owners.
IMPORTANT SAFETY
INSTRUCTIONS
READ ALL INSTRUCTIONS. KEEP FOR FUTURE
REFERENCE. INCLUDE ALL DOCUMENTATION
WHEN PASSING THIS PRODUCT ON TO OTHERS.
DANGER TO LIFE AND RISK OF ACCIDENT FOR INFANTS
AND CHILDREN!
Risk of suffocation!
Never leave children unsupervised with the packaging material.
The packaging materials pose a suffocation hazard. Children
frequently underestimate the dangers. The packaging materials are
not toys. This product is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given

7
US-EN
supervision or instruction concerning use of the product by a person
responsible for their safety. Children should be supervised to ensure
that they do not play with the product.
Risk of property damage
 This product does not contain any parts which can be serviced
by the user.
 Keep the product away from moisture, dripping and splashing
water!
 Do not place burning candles or other open fire on or next to
the product.
 Check the product before every use! Discontinue use if any
damage to the product or the charging cable is detected!
 If you notice smoke or an unusual noise or odor, unplug the
product immediately and remove the USB cable.
 Sudden temperature changes may cause condensation inside
the product. In this case, allow the product to acclimatise for
some time before using it again to prevent short circuits!
 Do not operate the product near heat sources, e.g. radiators or
other devices emitting heat!
Do not try to open the product! It has no internal parts requiring
maintenance.

8 US-EN
Radio interference
 Never use the product on airplanes, in hospitals, service
rooms, or near medical electronic systems. The wireless signals
transmitted could impact the functionality of sensitive electronics.
 Keep the product at least 0.65 ft / 20 cm from pacemakers or
implantable cardioverter-defibrillators, as the electromagnetic
radiation may impair the functionality of pacemakers.
 The radio waves transmitted could cause interference in hearing
aids.
 Do not place the product near flammable gases or potentially
explosive areas (e.g. paint shops) with the wireless components
on, as the radio waves emitted can cause explosions and fire.
 The range of the radio waves varies by environmental conditions.
In the event of wireless data transmission, unauthorized third
parties receiving the data cannot be excluded.
 Lidl US, LLC is not responsible for interference with radios or
televisions due to unauthorized modification of the product. Lidl
US, LLC further assumes no liability for using or replacing cables
and products not distributed by Lidl US, LLC. The user of the
product id fully responsible for correcting interference caused
by such unauthorized modification to the product, as well as
replacement of such products.

9
US-EN
Ensure that:
 no direct heat sources (e.g. heating) can affect the product.
 the product is not exposed to bright artificial light.
 any contact with splashed and dripping water and corrosive
liquids is avoided and the product are not operated in the
vicinity of water. In particular, the product should never be
submerged in liquid; do not place any vessels filled with liquid,
for example, vases or drinks, on or near the product.
 the product is not used in the immediate vicinity of magnetic
fields (e.g. speakers).
 no fire sources (e.g.burning candles) are placed on or near the
product.
 no foreign objects penetrate the product.
 the product is never subjected to extreme temperature fluctuations
as this could result in condensation and electrical short circuits. If
the product were subjected to extreme temperature fluctuations,
however, wait (2 hours) until the product has reached ambient
temperature before use.
 the product is never subjected to excessive shocks and
vibrations.
 the connected cables are always laid in such a manner that
nobody can step on or trip over them. There is a risk of injury.
 no objects are placed on a connected cable and cables are
not connected over sharp edges because this could otherwise
damage the functionality of sensitive electronics.

10 US-EN
Changes or modification to this product not expressly approved by
the party responsible for compliance could void the user‘s authority
to operate the product.
This product has been tested and complies with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This product
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this product causes harmful interference to radio or television
reception, which can be determined by turning the product off and
on, the user is encouraged to try and correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the equipment to an outlet on a different circuit than the
one the receiver is connected to.
• Consult the dealer or an experienced radio / TV technician for
help.

11
US-EN
This product complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This product may
not cause harmful interference, and (2) this product must accept
any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator
and your body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
SAVE THESE
INSTRUCTIONS

12 US-EN
PDescription of parts
1Qi Charging area
2LED indicator
3USB type C input socket
4USB type A plug
5USB charging cable
6USB type C plug
7Instructions for use

13
US-EN
1
23
4
57
6

14 US-EN
PTechnical data
Dimensions: 4 ½ x 3 1/16 x 2 ¾ in
(114 x 78 x 70 mm)
Weight: 4.9 oz (140 g)
Operating temperature: 41 – 95°F (5 – 35°C)
Storage temperature: 32 – 113°F (0 – 45°C)
Humidity(no condensation): 10 – 70 %
USB charging cable length: 3.28 ft (1 m)
Input: 5 V , 2 A
Output: 5 W max.
OR
Input: 9 V , 2.0 A
Output: 10 W max.
Total power: 10 W max.*
Frequency band: 110.8 - 147.0 kHz
Transmitted maximum radio
frequency power (H-field): -12.62 dBuA/m at
10m distance
Maximum distance
between charger and
mobile device: 0.2 in (≤ 5 mm)
*NOTE: To achieve the maximum output power of 10 W,
you must use a USB adapter with output voltage of 9 V and output
current of at least 2 A. Such USB adapter is not included in delivery.
(Only USB charging cable type A to type C is included.)
The specification and design may be changed without notification.

15
US-EN
PScope of delivery
1 Inductive Qi®charging station
1 USB charging cable
1 Instructions for use
PBefore use
NOTE:
 Before use, verify the package contents are complete and
undamaged!
 All parts have to be unpacked and the packaging material has
to be removed completely.
 If you notice any damage or missing parts, contact the dealer
who sold this product.

16 US-EN
POperation
ATTENTION! The product must not be charged at a PC or
notebook due to the high power consumption.
NOTE:
 The product only supports devices with Qi wireless technology.
Charge your mobile device
1. Plug the USB type A plug 4of the USB charging cable 5into
the USB port on a suitable USB adapter (not included) and plug
the USB type C plug 6into USB type C input socket 3of the
product.

17
US-EN
2. Plug the USB adapter (not included) into an easily accessible
mains socket.
3. LED indicator 2will light up blue for approx. two seconds when
the product is under standby mode and there is no mobile device
on the Qi charging surface 1.
4. Place the mobile device on the Qi charging surface 1. Make
sure the center of the device is aligned over the center of the
Qi charging surface. Charging will begin on contact. The LED
indicator 2lights up blue when charging is active on Qi
charging surface 1.
Protective covers that protect the mobile device may interfere
with the charging process. In this case, the mobile device must be
removed from the protective cover.

18 US-EN
*NOTE: The charging power is up to 10 W, depending on the
power adapter used.
LED indicator 2status
The product uses an LED indicator to show the operating status:
LED indicator Status
Blue lights up two seconds Starting process (Boot phase) /
Standby
Blue lights up Charging / Full Charge
Blue is flashing metal obstruction
Green is flashing Incompatible adapter or cable
connected
PTroubleshooting
What should I do if the LED indicator of the product is
not lit during starting process (Boot phase)?
 Check the USB cable connection between USB adapter (not
included) and the product. The USB cable must be firmly
connected.
 Check the connection between the mains socket and the USB
adapter (not included).
 Alternatively, the user must try another mains socket.

19
US-EN
What should I do if the mobile device does not get
charging ?
 Check that the mobile device have Qi wireless charging
technology.
 Check the mobile device is placed horizontally on the center
position of the charging area.
 Check that no foreign object blocking the charging.
 Check whether the mobile device is removed from the protective
cover.
What should I do if the LED indicator flashes blue?
 This indicates a metal obstruction occurred.
 Disconnect the connection immediately.
 Check that no foreign object blocking the charging.
 Let the product cool down for a while and try to use it again.
What should I do if the LED indicator flashes green?
 This indicates the incompatible adapter or cable connected.
 Disconnect the USB connection immediately.
 Choose the appropriate adapter, cross-check the adapter
manual and ensure it can be used for this product probably.
 Use the provided USB cable to connect with the product.
PStorage when not in use
Store the product in a dry interior, away from direct sunlight,
preferably in its original packaging.

20 US-EN
PCleaning
 This product has no internal parts requiring maintenance.
Moisture entering the product may result in damage.
 Ensure no moisture enters the product during cleaning to prevent
damaging the product beyond repair.
 Do not use abrasive, solvent-based or aggressive cleaners. These
can damage the surface of the product.
 Only clean the product with a slightly damp cloth and mild
washing-up liquid.
PDisposal
Dispose of the packaging through your local recycling facilities and
in compliance with all federal, state and local regulations.
Please note the package markings regarding waste
separation, indicated by abbreviations (a) and numbers
(b), meaning: 1–7: plastics/20–22: paper and
cardboard/ 80–98: composite materials.
Contact your local waste management authority for
additional information on how to dispose of the used
product.
To help protect the environment, please dispose of the product
properly when it has reached the end of its useful life, do not throw
in the garbage. Information on collection sites and their opening
hours is available from your local authority.