8SKM 550 B1
GB
After you have finished
using your appliance
1) Switch the appliance off using the rotary
switch r.
2) Set the rotary switch rto P and hold it in
this position until the drive unit zcomes to a
standstill (Image B).
3) Remove the lid.
4) Press down the release button eand move
the pivot arm tinto operating position 4.
5) Remove the attachment you have been using
from the drive unit z.
6) Remove the mixing bowl 6.
7) Clean the appliance (see section “Cleaning
and care”).
Working with
the continuous shredder
WARNING! RISK OF INJURY!
► To avoid personal injury and damage to the
appliance, never insert or place your hands
or any foreign objects into the feed tube.
► Always use the pusher and no other implement
or body part to push ingredients into the
appliance. Danger of injury due to rotating
parts!
► Switch from one accessory to another only
when the drive unit zis at a complete stand-
still! After being switched off, the drive unit z
will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being utilised are fitted with
their protective covers.
► Make sure that neither the kneading hooks 1,
the whisk 2, or the beater 3are attached
to the pivot arm t.
Proceed as follows to prepare the appliance for
operation using the continuous shredder 7:
1) Press down the release button eand move
the pivot arm tinto operating position 4
(see the section “Operating positions”).
2) Set the mixing bowl 6into place. The base
of the mixing bowl 6must click into the re-
cesses uon the appliance.
3) Press down the release button eand move
the pivot arm tinto operating position 1.
4) Remove the protective cover from the drive
for the continuous shredder (Image C).
5) Insert the continuous shredder 7into the
hub socket (aligning the marking “ ” on the
continuous shredder 7with the marking “
” on the pivoting arm t).
Turn it in an anti-clockwise direction until the
continuous shredder 7clicks firmly in place
(and the marking “ ” on the continuous shred-
der 7is aligned with the marking “ ” on
the pivoting arm t).
6) Set the drive shaft 0into place.
7) Depending on the task you want to perform,
place the cutting q, shredding 9or grating
disc 8onto the drive shaft 0of the continous
shredder 7.
8) Place the lid with the pusher wonto the con-
tinuous shredder 7(so that the marking “ ”
on the lid wis lined up with the marking “ ”
on the continuous shredder 7) and lock the
lid in (marking “ ” on the lid wis lined
up with the marking “ ” on the continuous
shredder 7).
9) Turn the rotary switch rto the required setting.
NOTE
► Do not press too much food into the continuous
shredder 7. Take note of the table in the sec-
tion "Recommended filling levels".
10) Add the ingredients through the opening in the
lid with the help of the pusher.