
■ 6 │ GB│IE│NI SKM 650 A1
–Fit the kneading hook 0, whisk qor
beater w (referred to in the following as
“the attachment”) to the drive shaft 7in
such a way that the two metal pins on the
drive shaft 7engage in the recesses of the
attachment 0 q w.
–Push the attachment 0 q w firmly onto the
drive shaft 7so that the spring compresses,
and rotate the attachment 0 q w anti-
clockwise a little way (towards ).
–Let go of the attachment 0 q w. It is
now sitting firmly on the drive shaft 7.
5) Put the ingredients into the mixing bowl 6,
observing the following table with the recom-
mended filling quantities:
Filling quantities for... min. max.
Yeast dough N/A 500 g
flour
Cake mixture N/A 400 g
flour
Heavy dough
(e.g. shortcrust pastry) N/A 400 g
flour
Cream 200 ml 1000 ml
Egg white
(weight class M) 2 12
Adapt the remaining ingredients in the recipe to
the respective maximum quantity.
CAUTION! PROPERTY DAMAGE!
► Do not exceed the specified maximum filling
quantities!
Otherwise the appliance will be overloaded.
► If the appliance is labouring: Switch off the
appliance, remove half of the dough and
knead each half separately.
NOTE
► Please note that during the kneading or stirring
process, the mixture in the mixing bowl 6
increases in volume or is pressed upward
slightly as a result of the movement. You
should therefore never fill the mixing bowl 6
right up to the top!
6) Press the release button 2and press the
swivel arm 1with the mounted attachment 0
q w downwards into the working position.
NOTE
► If you wish, you can fit the filling accessory 8
onto the lid 9:
–Press the filling accessory 8into the
cut-out on the lid 9.
Now you can add ingredients even during
operation.
7) Push the lid 9onto the mixing bowl 6.
8) Turn the rotary switch 3to the required level
(see the section "Speed settings").
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position "OFF").
2) Remove the lid 9from the mixing bowl 6.
3) Push the release button 2and move the
swivel arm 1to the highest position.
4) Remove the attachment 0 q w from the drive
shaft 7by pushing the attachment 0 q w
against the drive shaft 7and turning clock-
wise (direction ) at the same time. Then you
can remove the attachment 0 q w.
5) Remove the mixing bowl 6by turning it anti-
clockwise and then pulling it upwards.
6) Clean the appliance (see section "Cleaning
and care").