9GB
Clean the contacts on the battery/
rechargeable battery and in the bat-
tery compartment before inserting!
Remove exhausted batteries/
rechargeable batteries from the
product immediately.
Before first use (Fig. C)
Remove all packaging materials from the product.
Turn the product over and place it on a soft under-
lay to avoid scratching the surface. Loosen the
screw 6located at the cover of the battery com-
partment 5on the back of the product.
Open the cover of the battery compartment 5
on the back of the product.
Pull out the insulation strip from the battery
compartment 5.
Close the cover of the battery compartment 5
and tighten the screw 6.
Replacing the battery (Fig. C)
Turn the product over and place it on a soft underlay
to avoid scratching the surface. Loosen the screw 6
located at the cover of the battery compartment 5
on the back of the product.
Open the cover of the battery compartment 5
on the back of the product.
Remove the used battery, if present.
Insert a battery type CR2032 in the battery
compartment 5.
Note: Make sure you insert the batteries with the
correct polarity. This is indicated on the cover of
the battery compartment 5.
Close the cover of the battery compartment 5
and tighten the screw 6.
Operation
Set the product on a solid, level and flat surface to
weigh.
Weighing
Note: Always place the object you wish to weigh
gently onto the weighing surface 1to avoid damag-
ing the glass surface.
Briefly touch the button / TARE 3to switch on
the product. The LC display 2will show all dis-
plays for approx. 3 seconds.
Note: A slight touch of the button /TARE 3
and the button UNIT 4is sufficient to operate the
product. If there is too much pressure, the
product may cause tilting.
During this time the weighing equipment on the
product is adjusting. Afterwards the numerical
display 8will read „0“. The unit display 7will
show the last unit selected.
Note: if an object (e.g. a key) is already on the
weighing surface 1while switching on, the
numerical display 8will still read „0“.
Place the item you wish to weigh onto the product.
The numerical display 8will show the weight of
the item you are weighing.
Incremental weighing
Touching the button / TARE 3with the product
on will change the numerical display 8from the
reading to „0“. The „Tare“ symbol 9will appear.
Now add another item to weigh onto the product.
The numerical display 8will show the weight of
the newly added item.
If you remove the item added to the product, the
numerical display 8will again read „0“.
