Siqura HSD 62 Series User manual

IP PTZ dome with SFP Interface
(Siqura HSD 62x Series)
SFP Adapter Installation Instructions
To install the SFP interface safely into the HSD62x series cameras, follow these instructions. For safety information,
please refer to the Outdoor IP PTZ dome with D/N and Wide Dynamic Range (Siqura HSD62x Series) Safety
Instructions delivered with the camera. Failure to comply with any precaution, warning, or instruction noted there is in
violation of the standards of design, manufacture, and intended use of the module. Siqura assumes no liability for the
customer’s failure to comply with any of these safety requirements.
To install the SFP adapter
1. Unscrew the captive mounting screws and remove the RJ-45 end cap cover (pictured below).
2. Align the connector and insert the SFP end cap and screw in the captive mounting screws.
3. Insert the SFP connector.
4. Align the mounting bracket with the 22-pin connector as indicated by the red alignment sticker.
Important: Be sure to follow the HSD62x safety instructions with regards to optical safety and fiber handling
precautions.

© Siqura B.V. 2011
Version 1.0 (1103015-1)
HSD 62x SFP inst (MW07SP02)
w
ww.siqura.com *%199925412140-00%*
Siqura HSD62x SFP Installation Instructions
To mount the HSD62x camera
1. Make a hole in the wall or metal access plate for the cables and secure the supplied cable gland in the
wall.
2. Ensure that the weather resistant gasket is correctly attached to the mount.
3. Thread the cables through the wall mount and screw it onto the wall.
4. Attach the waterproof boot to the mini wall mount.
5. Thread the cables through the outdoor tube adaptor and fix it to the mini wall mount with the supplied
screws and washers.
6. Clip the safety wire to the dome camera.
7. To keep insects out, block the cable entry hole with the supplied sponge.
8. Connect the cables to the dome camera.
9. Attach the dome to the outdoor tube adaptor and fasten them together with the supplied screws.
Important: For SFP installations, align the red arrow on the SFP housing with the mounting bolt that locks the
tube adapter to the WM02S wall mount as shown in the figure below.